Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Help!! I don’t know the model
#1

Hi there, I just bought this the other day at a resale shop so there was no info about it other than “record player table”. I figured out the brand by myself but cannot for the life of me figure out the model. The turntable needs a new needle so that’s why I need the model, I believe there is another piece missing as well, also on the turntable. Any information would be fantastic, thanks in advance!!


Attached Files Image(s)
                   
#2

Looks like a 60s model. I believe Philco used Voice of Music changers in the consoles. You probably have to take a closer look at the cartridge to match a needle. Quite often the original cartridge has been replaced.
#3

Hi and welcome,
There's a possibility that the radio and the phono where sold as separate units. In this case the model number would be on found on each component.
As for the needle/cartridge I'd give these guys a try: https://thevoiceofmusic.com/catalog/phono_needles.asp  You may be able to send them a pic of what you have and go from there.

GL with w/project!

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
#4

That is very nice...  Something I am more familiar with have a similar VM unit my first wife just had to have..
Early American or Colonial design, I never cared for the Spanish or Mediterranean designs...  He, he, the V-M worked right up to the day she hauled it away during the divorce Icon_lol

BTW it was Solid-State, went through at least 6 needles and one ceramic cart. My favorite album was "Switched on Bach" at near full volume, she hated it...

Pliny the younger
“nihil novum nihil varium nihil quod non semel spectasse sufficiat”




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
trying to identify this wire type
Thanks to all for the feedback. As Arran said, it is probably an older replacement and yes it has a grid cap so I will ...georgetownjohn — 09:32 PM
trying to identify this wire type
It's possible that the red wire, actually a grid cap lead, is a very old replacement, I can't remember seeing a pre 1939...Arran — 09:18 PM
Gilfillan Brothers Car Radio?
Hi everyone,  Special thanks to Joe Rossi for tracking down this obscure radio and thanks to others who took up the hun...Antipodal — 08:15 PM
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM

[-]
Who's Online
There are currently 5138 online users. [Complete List]
» 1 Member(s) | 5137 Guest(s)
Avatar

>