1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Threaded Mode
Philco 42-1008 122 Phono Transformer
Micro9
Junior Member
**
Posts: 36
Threads: 15
Joined: Aug 2007
City: Glendale,AZ
#1

11-24-2020, 04:01 PM
The radio has been completely restored...All caps replaced and resistors that were out of tolerance.Radio plays well on Am
and shortwave with good fidelity.When I try to play MP3 or bluetooth thru the rca plug on the xformer,It sounds real tinny with very little bass.
Is there a problem with the transformer or is the phono xformer not able to have good bass response thru it?
Before I send the BOL off to Westek for rebuild I would like to know if that xformer is good.
Here is a link to the schematic from Nostalgia Air:  http://www.nostalgiaair.org/pagesbymodel...013487.pdf
The part number is:32-8196 for the xformer..The pri reads 103 ohms and the sec reads 1596ohms....RCA input reads around 10 ohms..
TKS in advance...
Find
jphouchins
New Member
*
Posts: 1
Threads: 0
Joined: Aug 2020
City: White Bear Lake State, Province, Country: MN
#2

01-17-2021, 06:36 PM
Those values for your transformer are correct. Good luck with your BOL. I have restored three of them and it is always satisfying to get them to work properly.
Find
« Next Oldest | Next Newest »




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM

[-]
Who's Online
There are currently 3217 online users. [Complete List]
» 1 Member(s) | 3216 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration