Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Circuit diagram- Philco S521B Radio
#1
Smile 

Hello, I'm new here.
I have a Philco Empire Automatic S521B Radio of GB (1938). I'd like to reactivate it, but I can't find on the internet a circuit diagram for this model. I have found a circuit diagram for Philco D521B but it isn't the same diagram which I need. I've attached photos of my radio. Is somebody able to help me?                    
#2

Hope this info is helpful. Welcome to the Phorum.   https://www.radiomuseum.org/r/philco_emp...521_b.html
#3

Hi and welcome,
Give this one a try:  https://www.radio-workshop.co.uk/service...20D521.pdf

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
#4

The OP has stated that a D521 schematic is not the same as an S.521B schematic.

malkmm - I found a Philco (UK) Service Bulletin for model S.521. It may, or may not, be the same as an S.521B but maybe it will help? I will send you a private message (PM) on this subject.

--
Ron Ramirez
Ferdinand IN
#5

Welcome to the Phorum!
#6

It looks like the S521B might be a battery set, though it's also possible that someone may have swapped in an A.C chassis into the cabinet of the battery set.
Regards
Arran




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Cannot Adjust an IF Transformer’s cores
The abilities of our 'Phorum Pholks" never ceases to amaze me! Fantastic fabrication, Joseph! I'm waiting now for...GarySP — 08:27 PM
PT-6 antenna connections
Thanks. I never realized that was a notch noted in the schematic as described. I’ll recheck my wiring.bridkarl — 08:13 PM
Cannot Adjust an IF Transformer’s cores
Thank you! I was quite new to the Phorum when I started this post, so I feel like it might be advantageous to publish a ...jrblasde — 08:07 PM
PT-6 antenna connections
Notice in the schematic the notch at the bottom of the antenna coil is between pins 3 & 4. Yes, pin 6 of the 7C6 is...RodB — 07:34 PM
bridkarl
I have two PT-6 chassis. On both there is a blue wire that runs from the above chassis transformer to pin 6 of 7C6. So t...bridkarl — 07:23 PM
Cannot Adjust an IF Transformer’s cores
Joseph, now you are an engineer!!RodB — 06:37 PM
PT-6 antenna connections
Hi, reading your explanation I can see the confusion. If you take it one connection at a time it should result in a desi...RodB — 06:34 PM
Cannot Adjust an IF Transformer’s cores
It works! I received the PCBs this morning in the mail, and put everything together. I reused the base from the original...jrblasde — 04:32 PM
PT-6 antenna connections
I seem to have lost my way on this PT-6. I see the antenna aerial transformer schematic - I’m reading pins 1 through ...bridkarl — 12:30 PM
40-150 General questions
Good thing you're a good electrician ... the pictures show a lot of rewiring in your future! Take care and BE HEALTHY!...GarySP — 11:52 AM

[-]
Who's Online
There are currently no members online.

>