Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

replacing artificial leather on a 46-350 radio
#1

has any one replaced the artificial leather and do you have any instructions on do it I need all the help i can get, thank you
#2

I have patched the covering for this model but never had to replace it. I did a restoration on a Zenith TO (R600 I think) and discovered techniques for replacing the skin on Zenith web sites. I would imagine it's much the same. If you can get the old sections off in one piece, maybe with a little heat and a blade, you will have a pattern for each piece. Take lots of pictures.
#3

The previous owner cut holes in one side so I removed the ends and all other leather. The ends came off in one piece but they seemed to have been formed around the corners no cut marks.
#4

Donald, do you have a picture of your radio?

"I just might turn into smoke, but I feel fine"
http://www.russoldradios.com/
#5

I have pictures on my phone but don't know how to download to your site I am not computer savy
#6

How - to add pictures:

https://philcoradio.com/phorum/showthread.php?tid=29

"I just might turn into smoke, but I feel fine"
http://www.russoldradios.com/




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 91 Speaker Replacement
The spider is glued on the cone and so is the voice coil. I think you can use a cotton swab dipped in acetone and carefu...RodB — 02:42 PM
Restoring Philco 37-604C
Yes I saw that. If I knew, I'd probably try to arrange for getting it myself. But I have just got one. Which does not m...morzh — 01:44 PM
Philco 38-2 Automatic Tuning
When you push the lever, you are supposed to rotate the disk to the desired station. Then the magnetic tuning will acqu...morzh — 01:42 PM
Philco 38-2 Automatic Tuning
I figure out the muting from another picture that helped. Now I need to know how the automatic tuning works. When I push...dconant — 12:11 PM
Philco 91 Speaker Replacement
How would I go about removing the spider from the cone?dconant — 12:04 PM
Philco 38-2 Automatic Tuning
Hello, I am having trouble getting my automatic tuning to stay unmuted. If I play with the tuning handle I can get it to...dconant — 10:51 AM
Does anyone make photofinish replacements?
Here’s the link to the DIY photofinish section of our site: klondike98 — 09:46 AM
Delco car radio Peko vibrator converstion issues
Hi Richard, Thx for posting the schematic.  As I remember as a kid, these were great performers for the time, likely...MrFixr55 — 08:56 AM
Delco car radio Peko vibrator converstion issues
hello mr Fixr, The Electro  Powersupply that I am powering the radio with has a huge choke plus a 10,000ufd electrolyti...radiorich — 10:58 PM
Delco car radio Peko vibrator converstion issues
How about putting a choke in the power supply? The big cap was likely an attempt to stabilize the DC. Kids who cre...MrFixr55 — 09:19 PM

[-]
Who's Online
There are currently 2256 online users. [Complete List]
» 2 Member(s) | 2254 Guest(s)
AvatarAvatar

>