Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Cleaning paint from 46-420 bakelite case
#1

Hello Experts,

I'd like some suggestions for the gentle removal of paint spots from a really nice Hippo bakelite cabinet. It polished up really nicely, but at some point it got flecked with paint. I can, with great effort, clean up each fleck with a fingernail. Maybe some has a gentler method.

Thanks,

Dave
#2

Rubbing compound on a Qtip or a dental pick easy on the pressure. David
#3

My favourite paint spot tool is a razor blade scraper, the type where a hard backed safety blade slides into a holder. I always round of the corners of the blade on sandpaper so they won't catch and scratch, then hold the scraper on a shallow angle and be gentle. They usually come right off.
#4

Thanks for the suggestions. Good Deal.
#5

Bakelite is resistant to solvent paint remover but not a caustic paint remover. Some Bakelite will be O.K. with oven cleaner lye. But I would not use it.

Never clean Bakelite with Windex, 409 or other "super" household cleaners. They can remove the top surface and permanently leave the finish dull.

Mechanically removing the paint has risks...  chas

Pliny the younger
“nihil novum nihil varium nihil quod non semel spectasse sufficiat”
#6

if its latex house paint xylene or sold in hardware stores as "goof off" will work




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Zenith H725
Here's what the inside of AM IFT2 looked like, and the other pic shows the discs I made to take place of the mica and ke...EdHolland — 07:40 PM
Zenith H725
IF2 will need replacement caps. The arcing was severe enough that the mica is pitted and holed where the HT flashed over...EdHolland — 04:04 PM
My Philco 37-116 Restore
Measuring from center tap like the tube voltages show. Cap 127 is isolated from ground. Cap 127 shown in upper left of p...dconant — 08:05 AM
My Philco 37-116 Restore
Are you measuring relative to the centertap or the GND?morzh — 11:57 PM
Philco 610B oscillator wiring
Still not clear on the wiring interface between the 6A7 and oscillator. After refering to the available schematics and s...Tubester — 07:18 PM
Refinishing Ideas
My 37-116 code 121 is the best sounding radio i have...a daily driver. Since we are talking about "changes". ...poulsbobill — 07:18 PM
My Philco 37-116 Restore
Hello, I finally got brave enough to take the cans off the Expander Unit. Got the grid cap wires replaced and back toget...dconant — 06:50 PM
Zenith H725
I got into the first AM IF can today, and found its mica was cracked. Amazing that it was still working. This one makes ...EdHolland — 06:10 PM
Philco model #20
AHH HA , I got it and can’t thank you fellows enough , when I changed the capacitors I took the advice and did not unsol...onlyrick — 02:24 PM
Zenith H725
Hello Ed, yes, I like letting projects run for few days to make sure they don't start acting up . Sincerely Richardradiorich — 01:03 PM

[-]
Who's Online
There are currently no members online.

>