Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Zenith 809 lacquer color scheme?
#1

Hello Experts, 

I'm refinishing a Zenith tombstone model 809. It was once ZOWIE! looking. I hope to make it look good again. It must have spent time in a damp environment.  I'm having the front speaker grill chromed. I'm interested in some opinions on original lacquer colors. I've seen a few online photo of the radio that have perhaps been refinished. From the original finish, and I did document it, I can see a couple of tones as well as almost black on some trim and edges. I wonder if anyone has researched or has one of these Art Deco babies in excellent condition. I would appreciate some opinions. 

Thanks, 

Dave
#2

Are the grilles in those actually chrome plated, or are they nickel plated, or polished aluminum?
Regards
Arran
#3

It is chrome. I cleaned it up with naval jelly. I took it to a plating company, and they're going to re plate it for me. The cabinet is looking good. It will look stunning.
#4

Depending on how corroded the chrome is, sometimes it's cheaper making a new part out of brass, and having that plated. The only sets I have with chrome parts are some transistor portables, and a trio of Canadian RCA A-20s, the chrome on the A-20s is like a car bumper, very thick. I think that chrome and aluminum speaker grilles was more popular in Europe, you can count the number of North American radios with them on two hands. At least it isn't all show the chassis has a tuned RF amplifier stage like an RCA 128.
Regards
Arran




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

[-]
Who's Online
There are currently 2942 online users. [Complete List]
» 4 Member(s) | 2938 Guest(s)
AvatarAvatarAvatarAvatar

>