Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

GE model GD-60
#1

Yesterday after a disappointing trip to the Hartville Flea Martket (don't get me started on it), I stopped in at an antiques shop nearby and bought an unusual little General Electric radio. I initially mistook it for an old intercom as it looks alot like one! Turned out it is a model GD-60 am "compact" radio with five tubes and one ballast tube. Radio is complete and in decent shape, but there was one moment of panic. I pulled the chassis to inspect it and was presented with a crumpled, butchered, crumbling, and flaking asbestos pad! ARG! I grabbed a dust mask and some disposable gloves and hauled the cabinet outside for an asbestos removal. I managed to get it removed, sealed in a plastic bag and disposed of safely. If it had been intact I would have left it alone, but this thing was falling apart! Plenty of vents in the bottom of the cabinet to keep things cool though. I will have thise little guy rebuilt soon. It is kinda unique looking. Icon_biggrin

No matter where you go, there you are.
#2

cool I have many radios with asbestos lining the wood under the chassis popular problem. By the way just bought a zenith 8G625 at a flea market. Old radios are so cool!
#3

I found one of those in an antique store several years ago. It had sat in water at some time. I refinished the cabinet, replaced decals on both knobs, and worked on the chassis. Just played it a few days ago...sounds good. One of my "keepers."
#4

Mine just went out with a group of radios to be rebuilt yesterday, so hopefully I'll hear it speak soon.

No matter where you go, there you are.
#5

Nice looking set!!! If your ballast tube is open it can be replaced with a diode on this set.
Good luck!
Terry

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
trying to identify this wire type
Thanks to all for the feedback. As Arran said, it is probably an older replacement and yes it has a grid cap so I will ...georgetownjohn — 09:32 PM
trying to identify this wire type
It's possible that the red wire, actually a grid cap lead, is a very old replacement, I can't remember seeing a pre 1939...Arran — 09:18 PM
Gilfillan Brothers Car Radio?
Hi everyone,  Special thanks to Joe Rossi for tracking down this obscure radio and thanks to others who took up the hun...Antipodal — 08:15 PM
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM

[-]
Who's Online
There are currently 5105 online users. [Complete List]
» 2 Member(s) | 5103 Guest(s)
AvatarAvatar

>