Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

RCA T8-14
#1

Just got a "parts" T8-14 from an ARF deal, and was able to combine the speaker and a couple of tubes from it with my own T8-14 to produce a great looking and especially sounding set. This is an 8 tube, single 6F6 output/6F5 driver, 5Z3 rectifier 4.5 watt max output set. Additionally, I discovered that my set had an 80 where the 5Z3 belongs, so the "donor" 5Z3 was especially welcome.
#2

A T8-14 was one of my first radio finds and still have it. Nice sounding and good looking set that I learned alot of the basics on. Does your set have the globe tuning knob still? Also curious if there are any knob labels on the cabinet other than the RCA Victor logo.... mine are either worn away or never had em and the logo is pretty faded. Otherwise it's a nice original survivor.

- Mike
#3

Hello, Mike: both cabinets only had the RCA logo on them, nothing else. Fortunately, both sets had the complete set of knobs including the "globe" knob. I just commented on your collection and especially the RCA sets. Pretty neat collection you have!!
The reception of my T814 is super. It is funny that these sets do not seem to be very popular on eBay and other radio sites.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM

[-]
Who's Online
There are currently no members online.

>