04-14-2011, 11:48 AM
I want to replace the 5 dogbone resistors. I can not find the equivelent part number/codes for these parts. I would appreciate any help you can give.
model 20 dog bone resistor values
04-14-2011, 11:48 AM
I want to replace the 5 dogbone resistors. I can not find the equivelent part number/codes for these parts. I would appreciate any help you can give.
04-14-2011, 01:39 PM
Why do you need the part numbers? You can't just go down to the Philco distributor and get these anymore...
Anyway, your wish is my command: (12) 50,000 ohms, part no. 4237 (15) 250,000 ohms, part no. 3768 (17) 500,000 ohms, part no. 3769 (18 ) 100,000 ohms, part no. 3767 (20) 500,000 ohms, part no. 3769 -- Ron Ramirez Ferdinand IN
04-14-2011, 04:15 PM
Here's some additional info where they are listed by wattage.
http://www.philcorepairbench.com/carbonres.htm And if yours aren't shown in the list click on the comparison pictures link. That is handy for all old dogbones, not just Philco. You will probably have to resort to modern values like 470k instead of 500k, etc. GL, Bill
04-15-2011, 08:21 AM
thanks for your help. Ron, which site has these part numbers? I understand you don't sell them.
04-15-2011, 01:14 PM
You aren't going to be able to find those parts any longer more than likely. I'd recommend you get modern equivilents...
Try http://www.justradios.com : http://www.justradios.com/rescart.html Look for ones that are as close as possible in the 1W Flame Proof column. They come in packs of 5. 50k ohm would = 47k ohm 250k = 250k 500k = 500k 100k = 100k Brian Mattson Coon Rapids, MN
« Next Oldest | Next Newest »
Users browsing this thread: 1 Guest(s) |
![]() |
![]() |