Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

New here
#1

Just had come my way a Philco Radio so while hunting out some info found this site ,seemed a good idea to join

I have been collecting and fixing Vintage electronics for many years now
#2

Welcome to the Phorum! You found the right place for Philco radios in particular, but also most every other brand built as well. Lots of friendly folks here willing to help any way we can. Take care and BE HEALTHY! Gary

"Don't pity the dead, pity the living, above all, those living without love."
Professor Albus Dumbledore
Gary - Westland Michigan
#3

Hi and Welcome aboard, 

What sort of Philco set did you find a US or Brit built one? It's always a treat to see the non US set as they are pretty common over here. Especially the pre war models.
Here at the Philco Phorum Philco's are our speciality!

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
#4

Welcome!

People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.
#5

Welcome to the Phorum!
Icon_wave
#6

Welcome to the Phorum. Like the handle "Fixitnow" is better than laterIcon_smile.

Paul

Tubetalk1
#7

Hello FIXITNOW,
Welcome aboard and glad to see you found your way here .
So What kind of Vintage equipment do you like collecting or working on ?

Sincerely Richard
#8

I have about 8 sets that need to be fixed "now". Paul

Tubetalk1
#9

Welcome to the website, Hope to hear from you now and then.  Icon_wink
#10

Welcome to the Phorum. David
#11

Hello Fixitnow,
Welcome aboard !
Sincerely Richard
#12

Welcome to the Phorum FIXITNOW Icon_wave

John KK4ZLF
Lexington, KY
"illegitimis non carborundum"




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM

[-]
Who's Online
There are currently 5103 online users. [Complete List]
» 1 Member(s) | 5102 Guest(s)
Avatar

>