Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Help identify my philco
#1

Hello,

Does anyone know what model this is or any other information?

Thank you in advance,
Sal

   
#2

Welcome to the Phorum! Could you possibly provide photos of the chassis? That would help identifying what model radio, anyway. I'm leaning toward it being a model 20 chassis based on what looks like the three operating knobs and the escuteon. Appears to have been cobbled into another makers cabinet, and not a bad job with the exception of the glaring red indicator bezel. Take care and BE HEALTHY! Gary

"Don't pity the dead, pity the living, above all, those living without love."
Professor Albus Dumbledore
Gary - Westland Michigan
#3

On first look the tuning knob is correct for a model 20, but the on/off and volume knobs are not. What are what look like black checkers on each side? The escuteon is a model 20, but would benefit with a brass screw instead of the sheet metal screw now attaching it. Others can jump in on the possible cabinet maker. Definite has the looks of a "Franken-Philco". Take care and BE HEALTHY! Gary

"Don't pity the dead, pity the living, above all, those living without love."
Professor Albus Dumbledore
Gary - Westland Michigan
#4

Hi Sal,

Sorry to say that Gary is right. It's either a Philco model 20 or 21, in another manufacturers cabinet.
#5

The cabinet looks like it belonged to a FADA lowboy of 1930-31 vintage, regardless someone added an adapter plate to the front panel to accommodate the different knob locations of the replacement chassis.
Regards
Arran
#6

To spc091:

Please post a back view of the set so we may see what is inside. Thanks.

--
Ron Ramirez
Ferdinand IN




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM
Model 28L
Hello, I'm restoring a Philco 28L and the output transformer is open. Part number of the transformer is 32-7020. Can...HORSTE — 10:32 AM

[-]
Who's Online
There are currently no members online.

>