Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Zenith 5-S-119
#1

 Is a Zenith top model 5-S-119 Cabinet with 6-S-330 Chassis some kind of home made configuration?

Glenn
#2

Yes, one is a 5 tube chassis and the other a 6 tube. Plus there are other cosmetic differences if you do a search for each.

John KK4ZLF
Lexington, KY
"illegitimis non carborundum"
#3

Thanks John, it does seem to be two pieces that someone put together (model 5-S-119 Cabinet with 6-S-330 Chassis) and not something from the factory.

Glenn
#4

I've been following the one you're referring to on a Canadian Auction site. A bit of a Frankenradio. Too bad that the correct speaker and plug are missing and the hand written band position markings may be difficult to remove. I think this could be a great project but for me, the current high bid is too much for this one.

Jim




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently no members online.

>