Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

A-361 radio
#1

Hi! I am new to the phorum.  I am looking for schematics for an 1942 A-361 Philco radio in a floor model cabinet.  The tuner string is broken and we would like to replace it and need to know how to correctly restring it.  Any help is appreciated!
Martha
#2

Hi Martha, and welcome.

You can find the service information for model A361 here:

https://philcoradio.com/library/download...20Book.pdf

Unfortunately, this does not include a dial stringing diagram.

The radio chassis is basically the same as the F-1942 auto radio, modified to operate on 110-115 volts AC. However, its service data also does not include a dial stringing guide.

https://philcoradio.com/library/download...20Book.pdf

There was a Dial Cord Stringing Guide published by Howard W. Sams & Company in 1947, but it does not include the A361 or the F-1942.

Judging from your location, there are two radio clubs near you - the Mid-America Antique Radio Club in Kansas City, and the Oklahoma Vintage Radio Collectors in Oklahoma City. Perhaps one of these clubs might be able to help? The club in KC has no website but has a Facebook page:
https://www.facebook.com/maarckc/

and OKVRC's website is:
http://okvrc.org/

Good luck, and sorry I could not help with a dial stringing diagram.

If there is anyone else here who knows this information, please share it in this thread.

--
Ron Ramirez
Ferdinand IN
#3

Hi and welcome,

Perhaps this will be a help: https://www.youtube.com/watch?v=65UTJP8w...iveOhSeven

After perusing the schematic I would get rid of 65 and 66. If they are leaky or short it will take out the power transformer in short order. I suspect it's a throw back from the car radio design using a vibrator. In that circuit it helps saves the contacts therein. They are unnecessary.

GL with your project!

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
#4

Great find, Terry - thanks for sharing! Icon_thumbup

--
Ron Ramirez
Ferdinand IN
#5

Just downloaded thanks.
#6

Thank you Ron, for the response!  I will follow up on your suggestions.  I have already tried the Kansas City site but didn't have any luck.  I took it up to someone up there to look at but since it has the car radio in it, as it should, they weren't able to fix it.  I didn't see any reference to a club in OKC, so I will look them up!  Thank you for the help! Martha




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Need Help to ID this radio 11 tube Philco
It is a 16B tombstone.morzh — 06:13 PM
Zenith H725
David - sorry, I reread your post and finally saw THD - now the % figures make sense. Thanks for explaining. The PSU...EdHolland — 06:06 PM
Need Help to ID this radio 11 tube Philco
Hi Everyone, New member but have been reading this for awhile for tips! Vaccum tubes were before my time so bear with ...Ken D. — 06:03 PM
My Philco 37-116 Restore
Thank you MrFixR55, I appreciate your comments very much. I do not detect much hum if any so I will be staying with the ...dconant — 05:15 PM
My Philco 37-116 Restore
Hi DConant Yes, you can replace chokes with resistors.  You do stand the risk of increased hum.  the solution is to inc...MrFixr55 — 04:23 PM
Zenith H725
1.7-3.9 %, a modified Sine wave inverter is around 25%. Most generators from big box stores run 10% at a 50% load. What ...David — 04:06 PM
My Philco 37-116 Restore
I am having a heck of a time doing the alignment on the AM band. I can't seem to dial in the 1500 KC oscillator. I can h...dconant — 03:35 PM
Zenith H725
David - I think I understand but what units are you discussing (Low of 1.7, high of 3.9)? Budget constraints for Ham ...EdHolland — 01:43 PM
My Philco 37-116 Restore
You're doing great. I wish I could be more involved, but my mind is right now preoccupied with the reason I am here in ...morzh — 12:21 PM
My Philco 37-116 Restore
Hope you guys are still with me. I have moved on to the alignment. I completed the IF alignment which was pretty muc...dconant — 10:47 AM

[-]
Who's Online
There are currently 727 online users. [Complete List]
» 1 Member(s) | 726 Guest(s)
Avatar

>