Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Antennas
#1

Hi guys. I've been MIA for a few years, moving house a couple times among other significant events keeping me from this hobby.

I listened to my Model 20 a fair amount during 2020 while working from home until the power stopped working. I finally had a look and discovered a poor original wire from the power switch. Replaced and it's back in business (except for an issue of occasional good signal that becomes poor and drops as the set warms up over a couple minutes. My original thought was a hot tube issue, but will start looking into it more this spring).

Now that I'm settled in a house, I'm thinking of improved reception for my radios. What do you guys think of a roof aerial or something mounted in the attic? I've used an assortment of plain wire antennas over the years that have been "ok", but would like better performance overall. I'm about 30 miles southwest of Chicago and can pick up a couple stations pretty well, but not much else. I'd like to listen to something besides the ballgame and political talk radio.

Greg

"We are here to laugh at the odds and live our lives so well that Death will tremble to take us."
#2

Quote:I'm thinking of improved reception for my radios. What do you guys think of a roof aerial or something mounted in the attic?
Good idea Icon_biggrin 

Give it a good ground too, short and direct to earth, not the ground for the wall outlet...

Chas

Pliny the younger
“nihil novum nihil varium nihil quod non semel spectasse sufficiat”
#3

Quote:Give it a good ground too, short and direct to earth, not the ground for the wall outlet...

I figured I'd run a long wire to the basement and ground it to the water main from the city. It's copper and certainly underground!

Greg

"We are here to laugh at the odds and live our lives so well that Death will tremble to take us."
#4

Hi Greg, as for an antenna, I’ve had great results using my landline phone line. In most homes, there are 4 wires in the line coming in. 2 of them are fore the phone and the other 2 have nothing on them. I hooked a .001mfd cap to either one of those and run a wire to my radio. That gets me about 60’ or more of antenna running from the house, up high and out to the pole on the street plus the extra footage run throughout the house. And now since we’ve done away with our home phone, I can put my radio in any room in the house and have access to that antenna from any phone Jack.

Ron

Bendix 0626.      RCA 8BX5.   RCA T64
Philco 41-250.    Philco49-500
GE 201.             Philco 39-25
Motorola 61X13. Philco 46-42        Crosley 52TQ
Philco 37-116.    Philco 70
AK 35                Philco 46-350
Philco 620B.       Zenith Transoceanic B-600
Philco 60B.         Majestic 50
Philco 52-944.    AK 84




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Zenith H725
Here's what the inside of AM IFT2 looked like, and the other pic shows the discs I made to take place of the mica and ke...EdHolland — 07:40 PM
Zenith H725
IF2 will need replacement caps. The arcing was severe enough that the mica is pitted and holed where the HT flashed over...EdHolland — 04:04 PM
My Philco 37-116 Restore
Measuring from center tap like the tube voltages show. Cap 127 is isolated from ground. Cap 127 shown in upper left of p...dconant — 08:05 AM
My Philco 37-116 Restore
Are you measuring relative to the centertap or the GND?morzh — 11:57 PM
Philco 610B oscillator wiring
Still not clear on the wiring interface between the 6A7 and oscillator. After refering to the available schematics and s...Tubester — 07:18 PM
Refinishing Ideas
My 37-116 code 121 is the best sounding radio i have...a daily driver. Since we are talking about "changes". ...poulsbobill — 07:18 PM
My Philco 37-116 Restore
Hello, I finally got brave enough to take the cans off the Expander Unit. Got the grid cap wires replaced and back toget...dconant — 06:50 PM
Zenith H725
I got into the first AM IF can today, and found its mica was cracked. Amazing that it was still working. This one makes ...EdHolland — 06:10 PM
Philco model #20
AHH HA , I got it and can’t thank you fellows enough , when I changed the capacitors I took the advice and did not unsol...onlyrick — 02:24 PM
Zenith H725
Hello Ed, yes, I like letting projects run for few days to make sure they don't start acting up . Sincerely Richardradiorich — 01:03 PM

[-]
Who's Online
There are currently 1261 online users. [Complete List]
» 1 Member(s) | 1260 Guest(s)
Avatar

>