Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Delco car radio set?
#1

Hi everyone, I realise that a photo of the set in question would make this easier and I hope to post one soon. But in the meantime someone may recognise this set from my description.The bloke I bought it from said he thought it had come out of a Chev.It is certainly American. The vibrator is 6 volt. So , so far it could be any set. But several tubes are Delco brand.And the valve lineup is a little unusual, using 7 pin miniature valves up to the detector and an octal 6V6 for output. Rectifier is a 6X5.The miniature valves are retained in their sockets with a natty spring clip like a spiral , in the centre hole of which  is lodged the  pinch or sealing knob of each valve. I have not come across these clips before.It is permeability tuned with black plastic buttons.The speaker output is via a single ceramic RCA socket . I had hoped to find a paper tag inside giving some clue but....nothing. Valve lineup is 6BA6,6BE6,6BA6,6AT6,6V6, 6X5 .If anyone can offer any pointers I'd be grateful.
#2

Try going to radiomuseum.org and enter your tube list in the appropriate search box. Leave a space between each one. I got 36 hits and half are car radios. Most are from the 1950s.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently no members online.

>