Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Alkaline or Heavy Duty batteries in our old portable radios?
#1

I've been on a vintage solid state kick again and have been tinkering with my old Zeniths from that era. I dug out my rebuilt Royal 2000 and realized the old sets of alkaline batteries I have been using are no longer trustworthy, so I bought two six packs of heavy duty Rayovac D cells at Big Lots for a little over $10 with the tax included. My realization is that this radio and others I have were made before alkaline batteries were even a thing and will work just as well with the cheaper carbon type. I have four batteries left over and another pack will allow me to get my Royal 3000 up and going as well. Might be interesting to see how long these batteries will last in the rebuilt Zeniths compared to the alkaline D cells. $10.65 for 12 batteries is a lot cheaper than even the store brand alkaline batteries in my area and there might be stores with the Heavy Duty even cheaper yet. Shopping around right now in my area is almost dangerous with constantly angry and careless drivers. So, now to make my Royal 2000 my Christmas radio!

No matter where you go, there you are.
#2

Doesn’t really matter what type even quality. What matters is forgetting that batteries have been left inside and the potential for leakage.

On older radios, often, there is a bypass capacitor across the battery at all times. If this capacitor is electrically leaking the battery will be slowly discharged inviting chemical leakages. This can be avoided by checking for this “phantom” current flow and correcting it.

Chas

Pliny the younger
“nihil novum nihil varium nihil quod non semel spectasse sufficiat”
#3

Never leave a battery in a radio! When you turn it off take them out. I am not happy with the way any batteries are being made at this time, brand name or store name most are JUNK! Sorry about the rant have purchased batteries and had them start leaking in a few weeks and still in the new packing.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Correct model 84 Ac plug an cord type
From what I read Philco went to using brown rubber power cords in 1936, so cloth was used in the 1935 and earlier models...Arran — 11:25 PM
Correct model 84 Ac plug an cord type
Hi Bruce, I have not worked on an 84, but in general, power cords for almost any radio prior to 1938 was cloth covered...MrFixr55 — 08:34 PM
Restoring Philco 38-14
OK, well, so after staring at the sch again, I realized the problem had to be the #12/12A padder. I put a scope on the o...morzh — 08:15 PM
Correct model 84 Ac plug an cord type
Hello Bruce, I mostly use brown far as my cloth powercords go ! Here is the plug that I have used bakelite Acorn style...radiorich — 08:05 PM
Correct model 84 Ac plug an cord type
Looking for as correct as can find the right Ac plug an the correct colored cloth line. Ive seen many old photos but mos...Bruce — 04:13 PM
Restoring Philco 38-14
Rod Two Y-caps make sense if you use them from L/N to the chassis; this is only makes sense in the transformer radios...morzh — 10:11 AM
Restoring Philco 38-14
Mike, I'm curious about a specific use of he Y cap. Lately I've seen a single cap across the power transformer primary. ...RodB — 09:01 AM
Restoring Philco 38-14
hello morzh , That sounds like a plan ! Sincerely Richardradiorich — 07:45 AM
Restoring Philco 38-14
Richard, It helped some, but I still had the whining when engaging the rear power strip (I did not realize it was fro...morzh — 07:07 AM
Restoring Philco 38-14
Hello morzh, Yes , that dreaded hum in my room where i do alighment I have my cable modem and router plus desktop plus ...radiorich — 11:25 PM

[-]
Who's Online
There are currently no members online.

>