Thread Rating:
  • 1 Vote(s) - 3 Average
  • 1
  • 2
  • 3
  • 4
  • 5

1964 Corvair Delco radio - caps
#1

Definitely an "other radio!" All transistor. Model 985832.
The caps all look like new. Delco brand. Sealed plastic. And all are soldered to a circuit board. Would they still be good after nearly 50 years?
And the metal can with 3 electrolytics, 4, 400 and 850 uf. That one, at least, has wire leads and would be easy to replace. I'm hesitant to heat up the circuit board unnecessarily.
Thanks.
#2

It will either work or it will not, usually the mode of failure is that the caps will have dried out resulting in low volume, and or distortion.
#3

Hello fenbach,
Yes, as Arran put it the capacitors will be dried out and need to be replaced !

Sincerely richard
#4

You are correct about the circuit board. It is a pressed wafer board similar to tube socket material and doesn't like much heat or moisture. Circuit traces will lift off if over heated.
#5

Black beauty caps are nothing but old style caps with a plastic coating, look nice but always bad! Me thinks you have the GM version of a black beauty. I know it does not look nice but when working on old printed circuit boards I clip the part and solder the new part to the studs and stay away from the PCB.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
HiFi (Chifi) tube amp build - but my own design.
Tim Would mounting he transformer vertically change the hum, if used without additional parts? Also, in these amps...morzh — 02:25 PM
Shadow Meter Bulb
Gary I doubt it would introduce any noise. We use similar lamps for the panel indication, 12V AC lamps: they are LEDs...morzh — 02:15 PM
Shadow Meter Bulb
Not sure if anyone has tried this but there are 6.3 volt miniature lamps in bayonet and screw-in base options available ...GarySP — 11:31 AM
Shadow Meter Bulb
Any 6.3 volt pilot light will work. I would use the brightest one I could find in my workroom. Be sure the dial is clean...RodB — 10:45 AM
HiFi (Chifi) tube amp build - but my own design.
Tim, nice write up and thanks for sharing !! Sincerely Richardradiorich — 02:47 AM
HiFi (Chifi) tube amp build - but my own design.
Well, this was a real "Hum-Dinger" :lol: ! This will be kinda long, but hopefully it will help others having t...TV MAN — 01:55 AM
Shadow Meter Bulb
Phorum members, I am trying to find the bulb # for PHILCO Shadow Meter part number 45-2180 that is from a 37-640 chassis...georgetownjohn — 06:53 PM
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM

[-]
Who's Online
There are currently 5102 online users. [Complete List]
» 1 Member(s) | 5101 Guest(s)
Avatar

>