Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

41-295 REFINISHING
#1

I'm going to refinish my 41-295 , but before I start to strip it, does anyone know if Philco cabinets used the "PHOTO FINISH" like Zenith did ? ,It looks like they didn't but not 100% sure Icon_confused:
#2

Hi Bill,
I don't beleive that set had Photo finish. Posting a picture of the area you think is PP we should be able to tell for sure.
Another way is to take a high power magnifier and look for the 'dots' that are usually seen on the PP areas.

I have a set in the basement I think is the same (I can't turn it right now around to check) But it does have inlaid wood strips in the front side pieces, and below the dial escutcheon.

There is a picture of a cabinet under restoration, and I did not see anything that looked like PP on that cabinet.
Philco did use photo finish on many sets, so it is best to check first.

Gary.
#3

THANK YOU , Ihave so Zeniths with the photo finish ,what can be done for them? ,BILL
#4

Here's a link from Ron's site about photo finishes. Hope it helps.

http://www.philcoradio.com/schooley/index.htm

Bill

Sent from my Pentium II on the AT&T Dial Network




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
1949 Motorola 5A9M
Haven't thought of Burgess batteres in a while  https://www.radionostalgia.ca/lib/Images/battery/us/burgess1D.jpgi ...Vlad95 — 03:50 PM
Philco Model 16 wiring question
Measure the voltages first, just in case.morzh — 02:19 PM
1949 Motorola 5A9M
Haven't thought of Burgess batteries in a while Mr. Fixer. Boston Edison always used Burgess in their Bright Star yellow...Paul Philco322 — 02:17 PM
1949 Motorola 5A9M
Thanks Sam. I'll let you know. I can probably scare some up from the local radio club.klondike98 — 02:07 PM
Philco 89 Code 123 Osc Coil
Hello,  I thought I would post my findings on my bad oscillator tickler coil. There were 27 turns on the outer coil b...dconant — 12:38 PM
Philco Model 16 wiring question
Thanks Morzh. So it appears I did wire it incorrectly and I have to switch the wires between pins 2 and 4.bobclausen — 09:24 AM
Philco 46-1209 strange behavior
No, it's not a problem, just during certain condition it could show up. Yes, an internal tube short could do that too. ...morzh — 09:13 AM
HiFi (Chifi) tube amp build - but my own design.
You sound guys are never satisfied. :crazy: :clap:RodB — 09:10 AM
HiFi (Chifi) tube amp build - but my own design.
I got some new ceramic octal tube sockets installed and also tried some different coupling caps.  The results:  The go...TV MAN — 08:42 AM
Philco 46-1209 strange behavior
I pulled the tube out and it's shorted from pin 1 to pin 2. I suppose that's the problem...sq65 — 08:12 AM

[-]
Who's Online
There are currently no members online.

>