Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 29 or 45
#1

Hello, I have just received a Philco lowboy where the tube layout label in the cabinet says 29 or 45. There is no label or markings on the chassis to say which it is. Is there some way to tell what I have? Also my search for a new dial came up empty on Radio Daze does anyone know if I can get one?

Thanks,
Dan
#2

29 chassis has a shadow meter while 45 chassis does not. Shadow meter is part no. 27 in the 29 schematic. compare it to the 45 chassis.
https://philcoradio.com/library/index.ph...ams-vol-1/

...and here's a series of discussions that Ron Ramirez did about his 29/45 restoration. This the link to Part 1 of 7.
https://philcoradio.com/library/index.ph...on-part-1/
#3

Thanks for the info Bob. Looks like a have a 45 (no shadow). Stuffing old paper caps is a bit more than what I care to do. Besides who will ever see them. I restuff electrolytic caps if there is no room under the chassis otherwise I leave the old ones in place disconnected.

Dan




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently no members online.

>