1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Threaded Mode
250 ohm micamold resistor
DJW
Junior Member
**
Posts: 4
Threads: 2
Joined: Dec 2024
City: Goldsboro State, Province, Country: North Carolina
#1

Yesterday, 10:35 PM
Thought I'd ask the experts. This is a Philco 38-12CI.  The 250 ohm resistor comes out to 261 ohms. I'm not sure what the tolerance of this resistor is. Can anyone advise, should I leave it or replace it?

Thanks.


Attached Files Image(s)
       
Find
RodB
Phorum Expert
*****
Posts: 1,020
Threads: 41
Joined: Feb 2015
City: Roseville, MN
#2

Yesterday, 11:07 PM
It's less than ten percent over. It's OK.
Find
« Next Oldest | Next Newest »




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
My first Philco radio.
Put it all together. Put the two little ball bearings and spring in a baggie. And the shaft and center knob is just layi...Oldie Goldie — 12:03 PM
My first Philco radio.
Okay gents I went at this with a fresh eye this morning. Cleaned everything all over again. There is wear and slop som...Oldie Goldie — 11:31 AM
Custom Hammond Power Transformer
I currently have no way of testing tubes other than eliminating all other problems first. Bear in mind that no tube t...DaleHCook — 07:31 AM
My first Philco radio.
morzh, the center shaft has one ball bearing than a spring than another ball bearing. The outer tube has three bigger ba...Oldie Goldie — 01:29 AM
My first Philco radio.
This assembly usually have 3 larger bolls, from the sides, and one smaller, at the bottom, under the shaft.morzh — 11:41 PM
250 ohm micamold resistor
It's less than ten percent over. It's OK.RodB — 11:07 PM
Custom Hammond Power Transformer
Boy howdy, that’s some nice custom testing equipment! I really do need to invest in a variac. I also have a tube tester ...jrblasde — 10:46 PM
250 ohm micamold resistor
Thought I'd ask the experts. This is a Philco 38-12CI.  The 250 ohm resistor comes out to 261 ohms. I'm not sure what th...DJW — 10:35 PM
My first Philco radio.
Maybe it's time to replace the 3 ball bearings. I've done it on a few sets to lessen the roughness in the tuning.Radioroslyn — 10:04 PM
My first Philco radio.
I have a theory. One of the three big balls bearings came out while the other two wouldn't slide out. I didn't think it...Oldie Goldie — 09:21 PM

[-]
Who's Online
There are currently 1961 online users. [Complete List]
» 5 Member(s) | 1956 Guest(s)
AvatarAvatarAvatarAvatar
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration