Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

philco model 16X
#1

Need some general help/info for a floor console model 16x.
-- the set does not have any knobs - what kind of knobs did the orig
set have? was it the rosette style, or octagon style?
-- set has a small box mounted on the chassis shelf. it has 4 terminals
labeled ant, gnd, black, red. I looked at the schematic but cannot find
where they connect (switch on box controls sw/standard wave)
-- there is a toggle switch wired to the chassis that is mounted on the
side of the cabinet, but is not the on/off switch. what does this
control?

this looks like a very nice set -- thanks for any help with questions

mike
#2

The Model 16X (console) came in this style with rosette knobs:

[Image: http://www.philcorepairbench.com/images/16Xearly.jpg]


and this later version with the black hex type knobs:

[Image: http://www.philcorepairbench.com/images/16Xlate.jpg]


The switch on the side is the QAVC on/off switch; see PHILCO SERVICE HINTS & TIPS - NUMBER 24
Model 16 and 17 Q-AVC Adjustment & Operation




The old antenna coupler screwed inside the console is from a Philco antenna system that used an outdoor dipole antenna with a balanced, twisted-pair lead in.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently no members online.

>