Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Ultra Rare Kutztown Find
#1

Kutztown was great as usual but I came across this rare little guy around the perimeter of all the action. It's a rare chairside with a 118 chassis. With only 500 made my chances of finding the speaker attachment is about as good as Ron Paul getting elected president I won't quit looking though! Maybe I can hook one up inside?

Note from site admin: Sorry, but the photo which was attached to this post is no longer available.
#2

Wow! Never saw one of those before. Ultra cool.

Phil aka Philbert Q. Desenex - Twin Cities, MN
#3

Uffda Wrote:Wow! Never saw one of those before. Ultra cool.
Thanx Phil! It was only 60 bucks and I too had never seen one either until I literally stumbled on it....
#4

Welcome...and Very nice catch! Icon_thumbup Very good price, too.

I once had the separate speaker cabinet that matches your set, but I later sold it. If I still had it, I probably would have sold it to you. Sorry. As you know, the separate speaker cabinets for any of the 1933-36 Philco chairside sets are very hard to find.

I can tell you that the separate speaker cabinet which went with your 118RX used a PM speaker inside. I seem to recall that there was also a small box that contained a choke to substitute for the field coil used in most 118 models.

A skilled woodworker like Kenny Richmond or Steve Davis could probably make a replica, if he had several photos and the original dimensions. You can see an original here:
http://www.philcoradio.com/gallery/1935a.htm#am

--
Ron Ramirez
Ferdinand IN
#5

Icon_thumbup




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
Usually a wave trap is for keeping IF signals from entering the antenna and from leaving the antenna. You feed an IF sig...RodB — 09:30 PM
Philco 60 Squealing
I just peaked it for the best signal at 600. NULL it for IF frequency, originally it would have been null for 500kh...Chas — 08:05 PM
Philco 60 Squealing
Wavetrap no longer matters.morzh — 05:19 PM
Philco 60 Squealing
Rod, I had checked out your suggestions but did not help. I did solder the ground rivets to the chassis as Chas suggeste...dconant — 04:52 PM
37-690 Bass Choke Replacement
Yeah, I know, Mouser and Digikey don't have "big iron" components. For some reason Philco was messing with the...Radiodial — 04:25 PM
37-690 Bass Choke Replacement
Yes, I just had to deal with that while repairing the 37-604 Philco. Exactly that value choke was gone. And the current ...morzh — 03:52 PM
37-690 Bass Choke Replacement
Ah, now where to find one. I've into this before on smaller sets, I now recall. Hammond makes one that is only rated...Radiodial — 03:27 PM
Philco 38-7 Speaker
Ask the admins to put them together. As for the renaming, while inside the thread, you simply press "New reply&quo...morzh — 02:23 PM
37-690 Bass Choke Replacement
This is the parts catalog. 32-7528 choke is 65H, 10mA, 2,250 Ohm inductance. Find a suitable one.morzh — 02:18 PM
37-690 Bass Choke Replacement
While troubleshooting the no bass amplification issue, I think I found the culprit. The choke #104 is reading 164K ohms....Radiodial — 01:42 PM

[-]
Who's Online
There are currently no members online.

>