Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 37-84 refinish advise.
#1

Hello from Ireland!
I have got a Philco 37-84 code 122 radio that I am restoring. It needs to be refinished. It has got a finish that I am not familiar with. It appears to be a painted wood grain effect with lighter and darker stripes No veneer, and it is cracking and flaking off. I was hoping that someone could advise me on the best way or the options of refinishing this cabinet.

Thanks in advance
Frank
#2

Hi Frank,

That is called a "Photo Finish," since it's a paper-based "picture" of wood-grain over the base, cheap wood.

See the PHOTO FINISH links for info and repair from the MISC INFO page on my site:

http://www.philcorepairbench.com/misc.htm
#3

Hi Chuck
Thanks for the quick reply.
I had a look at the site. It looks difficult to achieve a original finish particularly when there is stripes through it.
Thanks again for the info.

Regards
frank
#4

Also search the CABINET RESTORATION section of The Antique Radio Forums at http://www.antiqueradios.com

Photo-finishes have been discussed before at length and others have achieved very good results.

Good Luck!

Sláinte!

Chuck




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM
Model 28L
Hello, I'm restoring a Philco 28L and the output transformer is open. Part number of the transformer is 32-7020. Can...HORSTE — 10:32 AM
Philco 42-1008 conversion kit
I read about a kit to convert the variable speed changer in the Philco 42-1008 into a single speed unit.  That would rem...alangard — 09:30 PM
HiFi (Chifi) tube amp build - but my own design.
Tim Well...a chassis is metal. Magnetic or not, it does not matter. A transformer has some hum to it. It is natural. Th...morzh — 08:40 PM
Hickok AC51 tube tester
I thought the 83 tube was bad because it looked white but it tests strong. Blue gassy though. I checked the fuse, it was...martinj — 08:37 PM
Shadow Meter Bulb
Ross I am not sure what current limiting effect the incandescent provides. They are two different parts of the sch...morzh — 08:31 PM

[-]
Who's Online
There are currently 4884 online users. [Complete List]
» 1 Member(s) | 4883 Guest(s)
Avatar

>