Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Grill cloth problems
#1

I'm having problems with my new grill cloth sagging. I'm using an upholstery fabric with fiber backing, glued to a heavy weight cardboard using fabric glue. The cloth is sagging at each of the openings. I'm thinking that the glue is shrinking & stretching the fabric. Any suggestions on how to prevent this?
#2

An underwire bra will generally prevent sagging. Icon_wink
#3

Gravity is the monster some of us can not escape as has been pointed out. Tits inevatible.

If I am going to re-mount a pice of grill cloth on a cardboard, I get it damp then use a number of of sewing pins pins to pull it straight abd get it aligned, and then a drizzle of elmer's along the edges where the sun will never shine again, and leave it till the next day.
#4

Zapping the backside very lightly with several coats of spray can lacquer will stiffen it up. Don't spray so much that it 'wets' because that will show through.
#5

Thanks y'all!
Dave




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM

[-]
Who's Online
There are currently no members online.

>