Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Phuilco 41-280 / The Chassis is worse than I had expected
#16

Texasrocker Wrote:<<< snip >>> I just replied to a email from Rob in regards to restoring his 41-280. I am about 200 miles west of the DFW area, but will be happy to handle the full electronic restoration of this radio if Rob decides to proceed.

Yep, I got a quick and comprehensive response from Texasrocker... I'm feeling better about this little project with each passing day!

Well, except for all the hand sanding... sigh...

Texasrocker Wrote:I lived in the Dallas for many years, but relocated out of the traffic many yrs ago.

Man, oh man, you gotta respect judgment this good! Icon_lol
#17

Yeah Rob, I sure miss all my ol' friends in the DFW areas. Loved living there in my younger years for sure. I remember fighting the traffic for about 18 yrs. in the DFW areas. KRLD & KLIF are still two of my favorite stations! Nowadays, just before sun up,I turn on my 1936 Truetone D-723 with a longwire antenna outside my window and listen to the KRLD traffic reports from 200 miles away out here in the country. I remember being stranded in those traffic jams all too well. My wife also remembers. We just look at each other and say, "yep", been there, done that, and got the T-Shirt. Living in Austin for several yrs wasn't much better on the traffic situations either! Icon_lol




Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM

[-]
Who's Online
There are currently 4558 online users. [Complete List]
» 2 Member(s) | 4556 Guest(s)
AvatarAvatar

>