12-04-2011, 07:16 PM
The labels on my Mystery Control looked pretty bad, so I decided to measure out and make a repro.
Scanned an original, measured it out, then used Paint Shop Pro to do the finishing touches.
I hereby donate an original. Print it at 18.5 mm for the length, and you'll have it.
The font you want to use is Alternate Gothic LT No. 2
Note from site admin: Sorry, but the photos which were attached to this post are no longer available.
Scanned an original, measured it out, then used Paint Shop Pro to do the finishing touches.
I hereby donate an original. Print it at 18.5 mm for the length, and you'll have it.
The font you want to use is Alternate Gothic LT No. 2
Note from site admin: Sorry, but the photos which were attached to this post are no longer available.