Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Source for speaker grill cloth for model 70
#1

I was looking for a source for original speaker grill cloth for my model 70. I just checked out radiodaze but was horrified to see that they are discontinued. Does anyone here know of a good reliable source to find a replacement that mimicks the original?

tractorforum.com *** I reserve the right to be wrong
#2

No kidding? I'd hate to have to buy something from a Ben Franklin or Good Will. Hmmm.l

tractorforum.com *** I reserve the right to be wrong
#3

Holy crap guys. What's with all the DISCONTINUED?? That is scary. Guess I've been away for a little while Icon_confused

http://www.radiodaze.com/category/290.aspx

-Brian
If you collect or are interested in antique telephones, please visit Classic Rotary Phones
http://www.classicrotaryphones.com/forum/index.php
#4

Here's the story.

http://www.philcoradio.com/phorum/showth...p?tid=3606

--
Ron Ramirez
Ferdinand IN
#5

Look at ARS http://www.tubesandmore.com/

Pattern S-G431F might be as close as you can get (now).

"I just might turn into smoke, but I feel fine"
http://www.russoldradios.com/
#6

Those on-line pictures at ARS are hard for me to relate to the actual pattern because they're not very sharp. I have a sample of almost all the clothes but ARS uses a different # system than Grillecloth.com and RadioDaze so I can't really tell much about S-G431F.

My recommendation is to try and salvage the original piece or just find something that looks decent for the time being. Eventually a new source will be found and that Philco pattern along with some popular Zenith patterns should be among the first to hit the streets and you can replace it then.

John KK4ZLF
Lexington, KY
"illegitimis non carborundum"
#7

Eliot Ness Wrote:Those on-line pictures at ARS are hard for me to relate to the actual pattern because they're not very sharp. I have a sample of almost all the clothes but ARS uses a different # system than Grillecloth.com and RadioDaze so I can't really tell much about S-G431F.

My recommendation is to try and salvage the original piece or just find something that looks decent for the time being. Eventually a new source will be found and that Philco pattern along with some popular Zenith patterns should be among the first to hit the streets and you can replace it then.
The one in place now is fine, t's just not even close to the original, and looks a bit drab. I'll figure something out, or just wait until someone else picks up the torch!

tractorforum.com *** I reserve the right to be wrong
#8

No source right now but hopefully again soon, if not someone else will have to step up to the plate.
Regards
Arran




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
My Philco 37-116 Restore
Are you measuring relative to the centertap or the GND?morzh — 11:57 PM
Philco 610B oscillator wiring
Still not clear on the wiring interface between the 6A7 and oscillator. After refering to the available schematics and s...Tubester — 07:18 PM
Refinishing Ideas
My 37-116 code 121 is the best sounding radio i have...a daily driver. Since we are talking about "changes". ...poulsbobill — 07:18 PM
My Philco 37-116 Restore
Hello, I finally got brave enough to take the cans off the Expander Unit. Got the grid cap wires replaced and back toget...dconant — 06:50 PM
Zenith H725
I got into the first AM IF can today, and found its mica was cracked. Amazing that it was still working. This one makes ...EdHolland — 06:10 PM
Philco model #20
AHH HA , I got it and can’t thank you fellows enough , when I changed the capacitors I took the advice and did not unsol...onlyrick — 02:24 PM
Zenith H725
Hello Ed, yes, I like letting projects run for few days to make sure they don't start acting up . Sincerely Richardradiorich — 01:03 PM
Philco 46-480 Electronic Restoration
I am almost finished with this restoration. All which remains is the power transformer. I cleaned it up some time ago, b...jrblasde — 12:41 PM
Philco model #20
I seem to recall in some TRF sets there being a Local/Distance toggle switch that removes the B+ from the first 24 rf tu...RodB — 09:46 AM
Refinishing Ideas
Hi Doppelganger, After rereading your thread, did you mount the Zenith speakers in the two bottom left and right pos...MrFixr55 — 09:39 AM

[-]
Who's Online
There are currently 854 online users. [Complete List]
» 1 Member(s) | 853 Guest(s)
Avatar

>