Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

PHILCO 70 VS 90
#1

I am looking to obtain a Philco Cathedral. I have seen a number of 70's and 90's for sale on E-Bay and elsewhere. Is the 90 that much of a better performer than the 70 that it is priced so much higher at auctions, etc? From what I have read, the 70 performs quite well and there isn't that much of a difference between the two except for two tubes.

Any insight would be helpful.

Thanks to all
#2

Hi Madghost,
There are some differences. Just glancing at the schematic the 70 volume control is in the antenna circuit. The 90 has its own 2nd detector and avc. The 70 looks to me that it doesn't. Also The volume is also controlled by changing the bias on the cathodes of two of the 24 tubes on the 70. The 90 also has two stages of audio amplification before the final output tube. The 70 uses the same tube as the 2nd detector and audio amplifaction.
I'm sure Ron and Chuck could tell you more. Both of my 90's play great. With a good antenna I pick up many stations across the dial. Sorry to say I have never listened a 70. Icon_sad

Hope this helps
Terry
#3

And there are three versions of the Mdoel 90, the origninal; Early, Mid and Late.

See the Early Cathedrals section of my site.
#4

Hi Madghost

The early 70 and early 90 (using two Type 45 output tubes) share the same front end, and neither have AVC.

The "mid" 90, the most common version with a single Type 47 output, uses AVC which makes a HUGE improvement in performance; i.e. no "blasting" as you tune across the dial, and less prone to fading.

The late 90 (push-pull 47 outputs) and late 70 both have autodyne converters, and both have AVC, so again their front ends are similar.

Both are good performers. To make a long story short, the 90 has extra amplification in its audio section. It is slightly larger than the 70. And there is just something special about it, I guess, that makes it more desirable. Icon_smile

--
Ron Ramirez
Ferdinand IN




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Need Help to ID this radio 11 tube Philco
Yes the 16B as morzh pointed out. Specifically its the January 1935 model version of the 16B. There are a couple earli...klondike98 — 11:51 PM
48-482 rear panel help
Welcome to the Phorum, keithchip! How far you take a radio on cabinet restoration is a matter of personal preference. ...GarySP — 11:28 PM
48-482 rear panel help
I've recently finished the internal restoration of a locally purchased Philco 48-482. The cabinet is in ok shape except ...keithchip — 10:28 PM
Need Help to ID this radio 11 tube Philco
Welcome to the Phorum, Ken! Lots of help here for all of your restoration questions. Take care and BE HEALTHY! - Gar...GarySP — 07:59 PM
Need Help to ID this radio 11 tube Philco
Thank you. I went to your online library and found 2 schematics. I will download and compare to components!Ken D. — 06:31 PM
Need Help to ID this radio 11 tube Philco
It is a 16B tombstone.morzh — 06:13 PM
Zenith H725
David - sorry, I reread your post and finally saw THD - now the % figures make sense. Thanks for explaining. The PSU...EdHolland — 06:06 PM
Need Help to ID this radio 11 tube Philco
Hi Everyone, New member but have been reading this for awhile for tips! Vaccum tubes were before my time so bear with ...Ken D. — 06:03 PM
My Philco 37-116 Restore
Thank you MrFixR55, I appreciate your comments very much. I do not detect much hum if any so I will be staying with the ...dconant — 05:15 PM
My Philco 37-116 Restore
Hi DConant Yes, you can replace chokes with resistors.  You do stand the risk of increased hum.  the solution is to inc...MrFixr55 — 04:23 PM

[-]
Who's Online
There are currently 591 online users. [Complete List]
» 1 Member(s) | 590 Guest(s)
Avatar

>