Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Latest acquisition
#1

Thanks to my friend Ed in Ohio, I now have this neat addition to the collection:

[Image: http://philcoradio.com/gallery2/images/1...age_00.jpg]

A Model 43B, from June 1932. Philco's first complete, all-in-one all-wave receiver.

Anyone else find anything new/neat/unusual in the Philco line lately?

--
Ron Ramirez
Ferdinand IN
#2

Oooo! Beauty!
#3

Hi All,
Nice radio Ron. A fine catch! At the end of July I picked up a Philco 90 for $65.00. A lot was wrong upon inspection. The (tiger stripe)? veneer is mostly gone but the rest is o.k. The primary on the first detector coil was open. The speaker field coil was open also. The filter choke along with the output transformer were open too. The tunning cap had to be cleaned also.The choke and output transformer were ordered from Radio Daze along with a #47 tube. The detector coil break was on the first loop. The speaker field I wound with #36 guage wire. I only had a little over a half pound which gave me 2600 ohms so I put a 10W 500 ohm resistor in series. You talk about tough getting the speaker core out! Wow. I drilled and tapped a 1/4 bolt to hold it in. After a rebuild of the cap blocks, a few resistors and electrolytics it plays great!!
Last friday the wife and I went back to the same place and there sat another 90! I got this one for $43.00. It rained here all day Saturday so I tore into this one. Not much wrong but a lot of recapping and resistors. hopefully I can power up tomorrow. The chassis has a lot of rust though. Will have to start cleaning after I get it playing.

Terry
#4

Hmph! Some people have all the luck! Icon_biggrin

Great buys on your 90 sets. Now would you consider letting go of the rusty one? Icon_lol Just kidding of course. Congrats!

--
Ron Ramirez
Ferdinand IN
#5

Ron,
Thank you. I am kind of proud of them. By the way #2 is up and running Icon_lol

Terry
#6

Now, another acquisition:

This set came from the Olney auction this past Sunday.

[Image: http://www.philcoradio.com/images/phorum...ff/112.jpg]

It is a 112 Bel Geddes lowboy, has some minor veneer issues, and the knobs - well, two of the knobs are 1937-40 Philco, the tuning knob is from an RCA, and the off-on knob is missing. Cloth is not original. The chassis is the later version with push-pull Type 47 outputs (one of the Type 47 tubes is missing).

The price: $20. No-one bid against me. Oddly enough, other consoles brought more money than this one did.

A friend of mine says I "stole" this at the $20 price. What say you guys?

--
Ron Ramirez
Ferdinand IN
#7

Dang...!!! Very nice catch. Icon_eek
#8

Ron,
Your lucky I wasnt at that auction. Looks like its "philco season".
Nice finds!




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM
Hickok AC51 tube tester
Note that no power cord, power switch, or power transformer switch are shown. That (along with my experience with full s...DaleHCook — 07:09 AM
IF can wire size and Rubber mounts?
A pair of wire strippers can give you an idea of what the existing gauge of the wire leads are in the IF can, I think it...Arran — 06:07 AM
My last cabinet for this year
Hello Dan, That is really beautiful what great looking radio you have ! I have friends who live in Calgary and the wea...radiorich — 01:51 AM

[-]
Who's Online
There are currently 5630 online users. [Complete List]
» 2 Member(s) | 5628 Guest(s)
AvatarAvatar

>