Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Sparks-Withington
#1


I have a S-W Spartan Jr. Model 400 (according to the chassis plate.) I understand the S-W Models 410/420 are identical or darn close. I do not have the schematic. Looking the unit over I notice the covers on the main power xfrmr have been removed and several wires were crudely spliced to the winding, one has fallen off and it is virtually impossible to resolder it.

Are these transformers still available or am I out of luck. Also where is the power on/off switch. The volume control does not appear to serve double duty as volume/power on/off ??

I had an exchange with another forum member Bandersen who has restored one of these radios (beautiful job).
#2

Here's a detailed write up of my restoration project: http://mail.videokarma.org/showthread.php?t=247842

The power switch on mine is a toggle mounted through a hole in the side of the cabinet. However, there is a mounting bracket on the volume pot and a little wire stub that can flick the toggle. I have also seen other Spartons where the switch is mounted on the pot. I did some experimenting and found it wasn't that reliable as sometimes the wire would slip over the toggle and not switch it. I suspect that's why it was mounted on the side.
[Image: http://farm4.static.flickr.com/3390/4607...a053_b.jpg]
#3

Thanks, that is an interesting arrangement, primitive but functional. I'll have to check my radion to see if that apparatus is there. I believe a while back you asked if my chassis had 815 tubes - nope didn't see any. Thanks again.
#4

Actually I asked it it had a pair of 183 or 483 output tubes. Those are very hard to find so I had to slightly modify mine to use 71As.
#5

(03-11-2012, 01:36 AM)bandersen Wrote:  Actually I asked it it had a pair of 183 or 483 output tubes. Those are very hard to find so I had to slightly modify mine to use 71As.

Oops meant 183's - I'll have to look and see exactly what tubes are present. Sent Stephen Johnson a note to see if he has the schematic for this radio..cheers
#6

BTW a pair of 183s just sold for a bit over $200 Icon_eek

I hope you got lucky and have a good pair.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently no members online.

>