Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Square tube shields
#1

Is there a difference between the ones used in 37 (4 tabs or the base at the socket) and 39 (has the base that requires you to use a 'G' type tube?

John
Las Vegas, NV USA
#2

No difference in the shields themselves, only in the shield bases.

1937 shield bases are the best if you need to change a base out, because they only have four flat "fingers" that hold the shield, allowing you to use any type of tube that will fit the socket - G, GT or metal. But 1936, 1938 and 1939 bases have an opening where only a "G" tube will fit. (This did not apply to 1936 models as only standard base tubes were used in the 1936 Philcos, not octals.)

--
Ron Ramirez
Ferdinand IN




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
An attempt to remove the Field Coil from a G speaker
Arran The oxidation seems to go deep, a few layers. The break starts right there, but then it will occur on every la...morzh — 07:35 PM
An attempt to remove the Field Coil from a G speaker
Mike, This is just a thought, the are on the coil where the verdigris (green oxidation is) I wonder if that is where ...Arran — 06:32 PM
An attempt to remove the Field Coil from a G speaker
Mike; I've made a one or two spiders by using some card stock, and a razor blade, it took more then one try but they ...Arran — 05:48 PM
Philco 91 Restore Code ??
I wondered about that. Wish there was some place local to get this stuff.dconant — 04:20 PM
Philco 89 indicator light.
Bending the lamp bracket (moving the lamp, that is) can possibly change the shape of the pointer a bit, but not its loca...morzh — 04:01 PM
Philco 91 Restore Code ??
Because the usable power rating of it then is (3,200/20,000)*25W= 4W. Maybe a tad more due to the mass, but not much. Yo...morzh — 03:59 PM
Philco 89 indicator light.
Thank you Dan, that was the trick. I kept trying to rebend the lamp bracket but that wasn't doing anything to help.Jim Dutridge — 02:18 PM
Philco 91 Restore Code ??
20K 25 watt. I thought it was a 20 watt at first.dconant — 01:37 PM
My Philco 37-116 Restore
Nah, too much and not that important.morzh — 01:33 PM
Philco 91 Restore Code ??
What's the full value of that resistor?morzh — 01:31 PM

[-]
Who's Online
There are currently 2667 online users. [Complete List]
» 3 Member(s) | 2664 Guest(s)
AvatarAvatarAvatar

>