Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

And, finally...a Scott Philharmonic!
#1

A few weeks ago, I noticed someone had posted over at the E.H. Scott forum, wanting to sell an E.H. Scott FM Philharmonic in a Warrington cabinet.

The price was right, so I dipped into some savings and bought it.

[Image: http://www.philcoradio.com/images/phorum...786e6a.jpg]

It looked pretty nice to me, but when I saw the serial number, I knew I had to have it.

[Image: http://www.philcoradio.com/images/phorum...37b72a.jpg]

Notice the serial number starts with my initials (RR)?

I have never used a shipping service before, but since the set was in southeastern Kansas, I used Craters & Freighters for the first time. I have to say, they did a good job - the set arrived here undamaged.

[Image: http://www.philcoradio.com/images/phorum...b2fd77.jpg]

The set has no tweeters, and it is apparent that it never had any - there are no screw holes where they would have mounted. The woofer has a large "whizzer" cone.

All of the photos above were taken by the gentleman who was selling it for his neighbor.

I'll take some photos of my own and post here, after I clean this set up and reassemble it.

--
Ron Ramirez
Ferdinand IN
#2

Great findIcon_thumbupIcon_thumbupIcon_thumbupIcon_thumbup

Ron, if you keep on you may have to add a roomIcon_biggrin

Steve

M R Radios   C M Tubes
#3

If that's the same firm tht sent my My Hammond amd Tone cabinet from Colorado Springs to New York, can't say enough positive about them. It's a niche market, and not cheap, but a few of them know what they are doing. Good of you to mention reliable movers.

Got to downsize soon myself, its time, so need good current moving references too. Please post specifics and contact information.
#4

Icon_sick

Joe Bratcher near Louisville, KY
#5

OH..MY...GOODNESS!!!!

Icon_clapIcon_thumbupIcon_clapIcon_thumbupIcon_clapIcon_thumbup

That is a swell collection of Scotts, Ron!!!!
#6

Sharp, Boss!!! Icon_thumbup

Mike
#7

Ron, what a great find. Looking forward to the receiver pictures as well. Love to see it after a little dusting. Don't know how you have the time for this stuff. Looks like the chrome should clean up well. If you don't like it, send it out here!
Jerry

A friend in need is a pest!  Bill Slee ca 1970.
#8

Very nice find Mr Scott, 'er, I mean Ron.
I like the extra nice touch on the serial number plate lettering. meant to be.

Bruce
#9

Congratulations Ron Icon_thumbupIcon_thumbupIcon_thumbup

John KK4ZLF
Lexington, KY
"illegitimis non carborundum"
#10

What a beautiful set, Ron!!!

CongratulationsIcon_clapIcon_clap

Gene
#11

You're gonna like it. I had one years ago (chassis and speakers only), but the chromiumwas bad, and I wasn't up to stripping the chassis and re-donng them. I sold it.
#12

More photos.

First, the amp/power supply chassis after a good cleaning and polishing:

[Image: http://www.philcoradio.com/images/phorum..._00033.jpg]

Front view of the woofer, showing the whizzer cone:

[Image: http://www.philcoradio.com/images/phorum..._00035.jpg]

and a back view of the woofer:

[Image: http://www.philcoradio.com/images/phorum..._00034.jpg]

The entire set was quite dirty, with lots of mouse droppings. Even more trash was found at the bottom of the speaker pedestal...including the remains of a long-dead mouse. Icon_eek

Debbie and I cleaned the cabinet up, and I rubbed it down with Howard's Restore-A-Finish.

Now, a look in the back of the set, with the woofer and amp/power supply in place:

[Image: http://www.philcoradio.com/images/phorum..._00037.jpg]

The speaker mounting board has holes cut out for tweeters, but this set never had any - note the absence of screw holes:

[Image: http://www.philcoradio.com/images/phorum..._00038.jpg]

Now, a look at the back of the set with everything in place:

[Image: http://www.philcoradio.com/images/phorum..._00043.jpg]

I'll clean and polish the upper chassis later.

A close-up of the dial and knobs:

[Image: http://www.philcoradio.com/images/phorum..._00044.jpg]

And, finally, the reassembled Philharmonic as it now sits in our living room:

[Image: http://www.philcoradio.com/images/phorum..._00045.jpg]

--
Ron Ramirez
Ferdinand IN
#13

Sharp!!!Icon_thumbupIcon_thumbupIcon_thumbupIcon_thumbupIcon_thumbup

Happily back in Illinois..not.
#14

Another unfortunate illustration of Scott's infamous flash chrome plating, if only they had triple plated it like the car manufacturers did back then. The cabinet on this set was perfectly fine, no lifting veneer, warpage, or other signs of moisture and water damage but the chrome plating still has rusted through and bubbled off in places.
For some reason most of the Philharmonics seem to be housed in Warrington cabinets, same with the Phantom series, it most have been the default cabinet option when these were sold. By the way, did anyone notice the pattern in the grille cloth?
Regards
Arran
#15

Well, Arran, in this case, the rust spots on the chrome weren't entirely Scott's fault. It doesn't help when mice have been hanging around your Philharmonic. Icon_eek And I think we all know what mouse urine can do to a chassis, especially one that wasn't chrome plated. In this case, I think the chrome plating saved the amp/power supply so that it still looks decent. I think if it had not been chrome plated, it would have already rusted through in places.

I am still amazed that none of the connecting cables were chewed, nor the speaker cone - even though I found the remains of a long-dead mouse inside the speaker pedestal.

--
Ron Ramirez
Ferdinand IN




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Need Help to ID this radio 11 tube Philco
Philco 16 is not intimidating at all. Despite being an 11-tuber. 37-116 is indeed intimidating. 16 has good space unde...morzh — 04:11 PM
48-482 rear panel help
Thanks for the responses Gary and Bob. I'm a little surprised that there's no back panel - although I know older Philco'...keithchip — 04:09 PM
48-482 rear panel help
Gary is correct, there was not a rear panel on the 48-482. I restored one of those and its a great sounding radio that ...klondike98 — 03:24 PM
The list of my radio & TV collection!
A little light positivity in our feed... To nostalgic retro music... With English subtitles My new video on the contin...RadioSvit — 02:14 PM
My Philco 37-116 Restore
Ron and Mike I mentioned a 2 meg resistor not on the schematic. I stumbled on a changes note in Riders that mentioned th...dconant — 12:02 PM
Need Help to ID this radio 11 tube Philco
Here you go: Your the code 125Radioroslyn — 11:12 AM
My Philco 37-116 Restore
Hi Ron, Thanks for the input. I think I'm going to call it good enough. It does seem weird I can usually dial in othe...dconant — 08:01 AM
Need Help to ID this radio 11 tube Philco
Welcome, the radio looks intimating 11 tubes, wish you well.Jimradio — 07:49 AM
462ron
Hi Dan, it’s been 10 years since I restored the electronics on my 37-116 so I’m going on some foggy memories. I remember...462ron — 07:37 AM
Need Help to ID this radio 11 tube Philco
Yes the 16B as morzh pointed out. Specifically its the January 1935 model version of the 16B. There are a couple earli...klondike98 — 11:51 PM

[-]
Who's Online
There are currently 2116 online users. [Complete List]
» 1 Member(s) | 2115 Guest(s)
Avatar

>