Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

And, finally...a Scott Philharmonic!
#1

A few weeks ago, I noticed someone had posted over at the E.H. Scott forum, wanting to sell an E.H. Scott FM Philharmonic in a Warrington cabinet.

The price was right, so I dipped into some savings and bought it.

[Image: http://www.philcoradio.com/images/phorum...786e6a.jpg]

It looked pretty nice to me, but when I saw the serial number, I knew I had to have it.

[Image: http://www.philcoradio.com/images/phorum...37b72a.jpg]

Notice the serial number starts with my initials (RR)?

I have never used a shipping service before, but since the set was in southeastern Kansas, I used Craters & Freighters for the first time. I have to say, they did a good job - the set arrived here undamaged.

[Image: http://www.philcoradio.com/images/phorum...b2fd77.jpg]

The set has no tweeters, and it is apparent that it never had any - there are no screw holes where they would have mounted. The woofer has a large "whizzer" cone.

All of the photos above were taken by the gentleman who was selling it for his neighbor.

I'll take some photos of my own and post here, after I clean this set up and reassemble it.

--
Ron Ramirez
Ferdinand IN
#2

Great findIcon_thumbupIcon_thumbupIcon_thumbupIcon_thumbup

Ron, if you keep on you may have to add a roomIcon_biggrin

Steve

M R Radios   C M Tubes
#3

If that's the same firm tht sent my My Hammond amd Tone cabinet from Colorado Springs to New York, can't say enough positive about them. It's a niche market, and not cheap, but a few of them know what they are doing. Good of you to mention reliable movers.

Got to downsize soon myself, its time, so need good current moving references too. Please post specifics and contact information.
#4

Icon_sick

Joe Bratcher near Louisville, KY
#5

OH..MY...GOODNESS!!!!

Icon_clapIcon_thumbupIcon_clapIcon_thumbupIcon_clapIcon_thumbup

That is a swell collection of Scotts, Ron!!!!
#6

Sharp, Boss!!! Icon_thumbup

Mike
#7

Ron, what a great find. Looking forward to the receiver pictures as well. Love to see it after a little dusting. Don't know how you have the time for this stuff. Looks like the chrome should clean up well. If you don't like it, send it out here!
Jerry

A friend in need is a pest!  Bill Slee ca 1970.
#8

Very nice find Mr Scott, 'er, I mean Ron.
I like the extra nice touch on the serial number plate lettering. meant to be.

Bruce
#9

Congratulations Ron Icon_thumbupIcon_thumbupIcon_thumbup

John KK4ZLF
Lexington, KY
"illegitimis non carborundum"
#10

What a beautiful set, Ron!!!

CongratulationsIcon_clapIcon_clap

Gene
#11

You're gonna like it. I had one years ago (chassis and speakers only), but the chromiumwas bad, and I wasn't up to stripping the chassis and re-donng them. I sold it.
#12

More photos.

First, the amp/power supply chassis after a good cleaning and polishing:

[Image: http://www.philcoradio.com/images/phorum..._00033.jpg]

Front view of the woofer, showing the whizzer cone:

[Image: http://www.philcoradio.com/images/phorum..._00035.jpg]

and a back view of the woofer:

[Image: http://www.philcoradio.com/images/phorum..._00034.jpg]

The entire set was quite dirty, with lots of mouse droppings. Even more trash was found at the bottom of the speaker pedestal...including the remains of a long-dead mouse. Icon_eek

Debbie and I cleaned the cabinet up, and I rubbed it down with Howard's Restore-A-Finish.

Now, a look in the back of the set, with the woofer and amp/power supply in place:

[Image: http://www.philcoradio.com/images/phorum..._00037.jpg]

The speaker mounting board has holes cut out for tweeters, but this set never had any - note the absence of screw holes:

[Image: http://www.philcoradio.com/images/phorum..._00038.jpg]

Now, a look at the back of the set with everything in place:

[Image: http://www.philcoradio.com/images/phorum..._00043.jpg]

I'll clean and polish the upper chassis later.

A close-up of the dial and knobs:

[Image: http://www.philcoradio.com/images/phorum..._00044.jpg]

And, finally, the reassembled Philharmonic as it now sits in our living room:

[Image: http://www.philcoradio.com/images/phorum..._00045.jpg]

--
Ron Ramirez
Ferdinand IN
#13

Sharp!!!Icon_thumbupIcon_thumbupIcon_thumbupIcon_thumbupIcon_thumbup

Happily back in Illinois..not.
#14

Another unfortunate illustration of Scott's infamous flash chrome plating, if only they had triple plated it like the car manufacturers did back then. The cabinet on this set was perfectly fine, no lifting veneer, warpage, or other signs of moisture and water damage but the chrome plating still has rusted through and bubbled off in places.
For some reason most of the Philharmonics seem to be housed in Warrington cabinets, same with the Phantom series, it most have been the default cabinet option when these were sold. By the way, did anyone notice the pattern in the grille cloth?
Regards
Arran
#15

Well, Arran, in this case, the rust spots on the chrome weren't entirely Scott's fault. It doesn't help when mice have been hanging around your Philharmonic. Icon_eek And I think we all know what mouse urine can do to a chassis, especially one that wasn't chrome plated. In this case, I think the chrome plating saved the amp/power supply so that it still looks decent. I think if it had not been chrome plated, it would have already rusted through in places.

I am still amazed that none of the connecting cables were chewed, nor the speaker cone - even though I found the remains of a long-dead mouse inside the speaker pedestal.

--
Ron Ramirez
Ferdinand IN




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
New member
Hi. I specialize in refurbishing Predictas, but I'm in Chicago. If you can get it to me, I'd be happy to go over it. ...Bob Andersen — 06:43 PM
An attempt to remove the Field Coil from a G speaker
I have 3 G speaker, all with open Field coils. Today I pull one of the shelf and decided to try to remove the FC (spo...morzh — 06:07 PM
Philco 91 Restore Code ??
Thanks Mike. I will check them out.dconant — 05:52 PM
Philco 91 Restore Code ??
There is no such thing as bad Fluke. This said, they are expensive. A Fluke is easily 10x the price of comparable CCC...morzh — 05:45 PM
Philco 91 Restore Code ??
Hello Mike, Yes, I have 3 Fluke meters one being my first Fluke 77 and other being Fluke 87. My third is Fluke clamp -...radiorich — 05:04 PM
Philco 91 Restore Code ??
I knew that Fluke was the Cadillac so with that in mind what Fluke would you recommend I get?dconant — 03:53 PM
Philco 91 Restore Code ??
Yep. 10W is probably enough. Also, if the meter measures Farads, then it should also have that "Delta" button...morzh — 02:38 PM
Philco 91 Restore Code ??
I measured the current through the resistor I am using as a replacement for the speaker field coil and got 40ma. So that...dconant — 02:32 PM
Philco 91 Restore Code ??
No I'm not saying I don't own a DMM. I have a CCC one (Thsinde 18+). I forgot that could read caps. I did purchase a Flu...dconant — 02:28 PM
Philco 91 Restore Code ??
Are you telling me you do not own any decent DMM, that can measure capacitances from a few pF and up? Even todays CCC (C...morzh — 01:44 PM

[-]
Who's Online
There are currently 4561 online users. [Complete List]
» 1 Member(s) | 4560 Guest(s)
Avatar

>