Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Not sure what i have...HELP??
#1

Can someone tell me how to find out info about a set i have...it is a philco console, but i can't find a pic like it on here. the face of the radio is on the upper front, has wooden buttons for selction, but also has 4 large dials on either side of the face. Has several different countries listed on the face/...along with AM and aircraft and several more..don't remember the others and i am not where it is at the moment...if someone could point me in the right direction i would be most thankful

Deb (sorry don't have a pic at the moment)
#2

Hi Deb and Welcome to the Phourm!!!
Without a pic it going to be tough! You maybe able to find a small blue and white sticker on the inside of the cabinet that will display the model number. It may also be stamped in ink on the chassis. Most of the time it will be two digits a dash and one-three more digits. The first two will be the year it was made. Did you have a look in the Gallery??
Terry
#3

Thanks Terry, i kept looking thru the gallery and think i found one that is pretty close...It looks like the 40-215RX only the buttons are closer together and are wooden
#4

Philco never used wood push buttons. They where tenite which is an early type of plastic. Not known for it's longevity most have badly deteriorated by now. Replacements are available. Maybe someone hand carved wooden replacements?
Terry
#5

Hello, Deb: try to get a pic to post here on the Phorum, that would be a major help in pin-pointing what you have.
#6

She figured out at it's a 41-295. Now she try to find it's worth. I gave a few ideas...
Terry
#7

Zehr gut!!!




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM

[-]
Who's Online
There are currently 7245 online users. [Complete List]
» 3 Member(s) | 7242 Guest(s)
AvatarAvatarAvatar

>