Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

RCA Victor R-15
#1

Could someone with Riders volume 1 scan a copy of the schematic for the RCA Victor R-15 for me? I believe it is on 1-14 under RCA Victor.

The copy on Nostalgia Air is unreadable and Riders Vol 1 is one that I don't have.

Thanks

-Keith
#2

It's also a Radiola 48. The big, heavy vertical TRF chassis, right?

Those sets must have been in a contest with the Baldwin Locomotive Company for weight. However, they were reportedly very good sets.

I'm sure I have the RCA Radiola 48 service book, but just where to look is the problem.
#3

The early Victors are surprisingly GOOD receivers for TRF sets. I had an RE32 that had amazing reception. It had, if I remember correctly, FOUR RF amplifier circuits before the detector.

HOWEVER, the Victors are TOUGH to work on.
#4

Keith, I have a copy of the R-15 from Vol I that you requested. Let me know how to get it to you.It is a pretty good copy.

Dave D
#5

Ijust did a google search for: "RCA Radiola 48. It has the entire RCA service booklet with a clear full page schematic diagram, as well as the rest of the book.
#6

Thanks Dave and Doug for the info.

I hope it turns out to be a good performer. I have had it for a few years now got it from my parents for a birthday present. It's missing the dial bezel which i have been hunting for since I got it. The cabinet is in good shape except for the veneer on the top is shot and will need to be replaced. The press wood looks very good.

-Keith
#7

Keith: you might want to take a look at the radiolaguy website, he may have what you are looking for....




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently no members online.

>