Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 40-216 Loop Connection Question
#1

http://www.nostalgiaair.org/PagesByModel...013346.pdf

When I first received the radio, the loop antenna connections to terminals 1, 2, 3 and ANT and the rear chassis were as follows: 1:White/Green from loop, 2:White from loop and lead to short wave loop, 3: Black from loop, ANT: No connection. When I restored the set, I followed the schematic. 1:White/Green from loop, 2: Short wave loop, 3: White, ANT: Black. This did not work too well, and adjusting the automatic tuning antenna trimmers had no effect (the OSC adjustments worked).

Just looking at resistances on my radio, White/Green to Black: 1.1 ohm. White/Green to Black and White to Black: 11K. So it appears that on my radio, black and white from the loop are switched. So I reconnected the leads as follows:
1: White/Green, 2: Short wave loop, 3: Black, ANT: White. This seems to work better, but still some of the ANTENNA trimmers have no effect and others very little.

Any clue as to how I should connect the loop leads to terminals 1, 2, 3, and ANT?

Thanks!




Users browsing this thread:
[-]
Recent Posts
Cannot Adjust an IF Transformer’s cores
It works! I received the PCBs this morning in the mail, and put everything together. I reused the base from the original...jrblasde — 04:32 PM
PT-6 antenna connections
I seem to have lost my way on this PT-6. I see the antenna aerial transformer schematic - I’m reading pins 1 through ...bridkarl — 12:30 PM
40-150 General questions
Good thing you're a good electrician ... the pictures show a lot of rewiring in your future! Take care and BE HEALTHY!...GarySP — 11:52 AM
40-150 General questions
I think RobB has it right. It is a part number and looks like its stamped on the chassis and that wasn't something you ...klondike98 — 11:41 AM
40-150 General questions
It's most likely a part number. Most of Philco part numbers are in that format. I looked at the parts list for this mode...RodB — 08:10 AM
40-150 General questions
Hi Kevin, No, I don't but I like your Quote about being a good electrician. The way I look at it is "The fact ...MrFixr55 — 08:06 AM
Philco 38-7 Speaker
7K should be fine. While not a perfect match (This transformer is meant for 6V6 tubes), Antique Electronic Supply (AES)...MrFixr55 — 08:03 AM
40-150 General questions
I discovered a stamp on the underside of the breadboard on my Philco 40-150. It is"56-1417' in black ink with numbe...Kevin_D — 07:14 AM
Philco 38-7 Speaker
FYI the Impedance of the HR20 (the one I have) secondary of the audio transformer is 5 ohms. The 38-7XX speaker is suppo...tludka — 04:22 PM
Philco 38-7 Speaker
Yeah, don't use the transformer currently on the H-20 (Dopf, I thought "H20, is that new technology, a speaker usin...MrFixr55 — 03:51 PM

[-]
Who's Online
There are currently 2632 online users. [Complete List]
» 1 Member(s) | 2631 Guest(s)
Avatar

>