Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

hum in 116B
#1

I have acquired a hum in my set.
I was going to sell it but pulled it.the shadow meter seems to want to work but does not. moves slightly left or right and stops.
I think it used to work before. If the hum was from a power supply filter,it would be there all the time wouldn't it?

this hum is only on station and in between stations there is no hum.
Does the shadow meter work off of an IF tube?
Where do I start.
David F
#2

Thanks anyway-I will sell it as is.
#3

Many things can cause weird noises in vintage radios. If you havent changed the filter caps yet, that is most likely the source!!! However, common household items such as modern type florescent-lighting near your radio, TVs that are turned on, microwave ovens, clothes washers ( motors put out RF!!), clothes dryers, AC line "hash" coming into your home ( hence, a neighbor down the street firing up his home arc-welder connected to the same overhead pwr lines), ALL cause static & weird hums in vintage tube radios especially if on or near each other at the same time. If the radio has had a complete "re-cap", check your surroundings , turn off all other electrical appliance devices, and try again. If the radio hasnt had a complete recap, the old "filter caps" are telling you to unplug the radio, and sell it before you take-out a pwr transformer, ( if it has one). Just trying to help. Randal




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco Model 80 Transformer resistance
Just forget this number, it is useless anyway. Simply proceed with your project.morzh — 10:08 PM
Philco Model 80 Transformer resistance
My $0.02 is that it is a misprint. I tried to look up the value for the similar 84 and 37-84, and ther is no resistance...MrFixr55 — 09:51 PM
Philco Model 80 Transformer resistance
Thanks for the quick reply! Hmm...well that's good, so what am I seeing that's 1042 ohms on the schematic for the pow...Mike L — 08:46 PM
Philco Model 80 Transformer resistance
The DC resistance of the primary is 8 to 9 Ohm.morzh — 07:54 PM
Philco Model 80 Transformer resistance
I have a feeling the primary winding on the power transformer is bad. My resistance reading on the primary side is 9 ohm...Mike L — 07:48 PM
Rusty Tuning Condenser
I would try Naval Jelly and use a soaked pipe cleaner to get it where it needs to go.RossH — 06:56 PM
38-10T chassis Restoration begins
Hello Dconant , they sold mica to use as a insulator between transistors and their heatsinks too. Rob I will remove th...radiorich — 02:52 PM
38-10T chassis Restoration begins
Thanks for the info guys. I always wondered why the use of mica. Now I know.dconant — 01:52 PM
38-10T chassis Restoration begins
Most common plastics have a dielectric constant in the 3-4 range whereas mica is around 6. This means that even if you w...Steve D — 01:46 PM
38-10T chassis Restoration begins
It is acceptable but not desirable. Plastic is not an approved cap dielectric, and even though a reasonably thick piece...morzh — 11:52 AM

[-]
Who's Online
There are currently no members online.

>