Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

40-216, 41-316 and similar sets - WHAT'S WITH THE HOLE?
#1

I recently acquired a Philco 40-216 with remote control. The cabinet has a hole about 3/8" in diameter in the center of the cabinet right below the fold-up cover. I looked at other similar sets such as a 39-45, 41-316, and 39-116 in various galleries and they ALL seem to have the same hole. It looks like something is MISSING. But WHAT? And why do ALL sets I have seen have this hole?

Does anyone know what might be missing and have a photo?

Thanks
#2

Very simply, a pilot light. There was a plastic jewel that went in there. I use to have a 42-1015. I used to be able to get red jewels from when I was in the vending business years ago. It was for a "use coin only" light. I used the little piece from the top of a red Bic pen in some cases now. It's not transparent like the originals but works. The originals disintegrated and turned to powder which is why they are always missing.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Cannot Adjust an IF Transformer’s cores
The abilities of our 'Phorum Pholks" never ceases to amaze me! Fantastic fabrication, Joseph! I'm waiting now for...GarySP — 08:27 PM
PT-6 antenna connections
Thanks. I never realized that was a notch noted in the schematic as described. I’ll recheck my wiring.bridkarl — 08:13 PM
Cannot Adjust an IF Transformer’s cores
Thank you! I was quite new to the Phorum when I started this post, so I feel like it might be advantageous to publish a ...jrblasde — 08:07 PM
PT-6 antenna connections
Notice in the schematic the notch at the bottom of the antenna coil is between pins 3 & 4. Yes, pin 6 of the 7C6 is...RodB — 07:34 PM
bridkarl
I have two PT-6 chassis. On both there is a blue wire that runs from the above chassis transformer to pin 6 of 7C6. So t...bridkarl — 07:23 PM
Cannot Adjust an IF Transformer’s cores
Joseph, now you are an engineer!!RodB — 06:37 PM
PT-6 antenna connections
Hi, reading your explanation I can see the confusion. If you take it one connection at a time it should result in a desi...RodB — 06:34 PM
Cannot Adjust an IF Transformer’s cores
It works! I received the PCBs this morning in the mail, and put everything together. I reused the base from the original...jrblasde — 04:32 PM
PT-6 antenna connections
I seem to have lost my way on this PT-6. I see the antenna aerial transformer schematic - I’m reading pins 1 through ...bridkarl — 12:30 PM
40-150 General questions
Good thing you're a good electrician ... the pictures show a lot of rewiring in your future! Take care and BE HEALTHY!...GarySP — 11:52 AM

[-]
Who's Online
There are currently 4234 online users. [Complete List]
» 1 Member(s) | 4233 Guest(s)
Avatar

>