Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Electrolytic cap question
#1

One part of my radio collection I really love are the memories I have of getting them, especially the first ones I got when I was a teenager. Recently I pulled a 1937 Detrola model 137 out of hiding in my attic. I remember getting this set at a Fall fleamarket way back in 1981 for 15 bucks. I remember being really excited about this find as at the time it was the second oldest radio I had gotten. i played around with it for awhile, but not yet really knowing alot about electronics, I never did get it to play. Fast forward 32 years and I have rediscovered it and have decided that it was time to fix that.
It's an early AC/DC set and there is not a lot of room under the chassis. I would like to restuff the original electrolytic cans not only to preserve the look, but for space issues as well. So after pulling the cans off the chassis, I discovered that there is still liquid in them. I've restuffed electrolytic cans before but they have always been dried out. My question is, Is the liquid in the cans toxic or hazardous? What is it made of anyway? Any one have any input? Thanks!
Kevin
#2

I believe it is a boric acid solution. Toxic only in large quantities. Also used in ant poisons {it works} and as an antiseptic. Use normal precautions--safety goggles and thin painters gloves.
#3

It's borax based, maybe a boric acid solution, I don't know for sure. I use to have some that I salvaged from a bad cap and stored in a jar, the cap had a dead short so was useless even though it wasn't dried out. If I find it again maybe I will get the liquid analyzed. No it isn't particularly toxic, not to humans and higher animals anyway, but it does kill insects and it does kill mold. The reason it's effective in killing ants is that they can't taste it, so it will mix right into sugar, peanut butter, or other things they like, which, being the community spirited insects they are, will tell the other ants about it and then take some back to the nest.
Regards
Arran




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
trying to identify this wire type
Thanks to all for the feedback. As Arran said, it is probably an older replacement and yes it has a grid cap so I will ...georgetownjohn — 09:32 PM
trying to identify this wire type
It's possible that the red wire, actually a grid cap lead, is a very old replacement, I can't remember seeing a pre 1939...Arran — 09:18 PM
Gilfillan Brothers Car Radio?
Hi everyone,  Special thanks to Joe Rossi for tracking down this obscure radio and thanks to others who took up the hun...Antipodal — 08:15 PM
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM

[-]
Who's Online
There are currently no members online.

>