Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

inquiry
#1

Total Newbie to vintage radios. I have been asked by a relative to see if these 2 console radios have any value.
Model 650X (as near as I can determine)
Model 41-280

Both are in reasonably restorable shape. My Aunt claims that my uncle listened to them often over the years, but has not for approximately 5. I was reluctant to plug them in and try them, but will soon when I return.
They are located in Myrtle Beach,SC. I am in NY.

Thanks
#2

Hi and welcome!

First off DO NOT PLUG IN THOSE SETS!

You can cause irreparable and permanent damage or
worse.

The sets need to be fully restored by a knowledgeable antique radio repair person.

Find an antique radio club near you. Many clubs offer or have persons who can help you with restoration.

Both sets are "keepers". The 1936 Model 650X is especially a good set - well worth restoring. Value is priceless, since it's in the family.

Same with the 1941 Model 41-280 console. You can't put a value on them, since they are heirlooms. Those sets have a family history and it's good that you're getting them back to working condition.

Chuck
#3

Monetarily the 650X is worth more then the 41-280 but it's still not a high dollar set. If they have been in the family since new that makes them worth more to you then to someone else. Both are decent performing sets when they are working properly, but the 650X would be easier to work one as it won't need to be rewired.
Regards
Arran




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Need to purchase some accessories for restoration of my Old Philco Radio
Hi Paulo, Welcome to the Philco Phorum. I can see why you want to find good reproduction parts. That is a bea...MrFixr55 — 11:10 PM
HiFi (Chifi) tube amp build - but my own design.
Tim, I have some bakelite sockets in my work shop that I can dig up. I believe quite a few are NOS. I will take photo...RodB — 10:03 PM
Philco 610B oscillator wiring
> The cathode as noted is wired directly to the ground side of the heater filament for that tube, not to the #17 and ...Radioroslyn — 08:12 PM
HiFi (Chifi) tube amp build - but my own design.
Tim; I noticed your post a little late, but I would take one of the junk sockets and try to break a chunk out of it wi...Arran — 08:07 PM
Need to purchase some accessories for restoration of my Old Philco Radio
Here is a list of resources found in our online library that you might find useful. Mike's Gobs of Knobs email addres...klondike98 — 01:46 PM
First Radio restoration
Hi Tubeman, Welcome to the Philco Phorum.  Phamily Phriendly Pfun with Phine Pholks Phull of Philco Phacts. (See a p...MrFixr55 — 12:33 PM
First Radio restoration
You could post in the WANTED ADs section here on the Phorum and see if anyone has an RF generator that they want to sell...klondike98 — 11:55 AM
Zenith H725
Good ideas, thank you Arrange and Rich. I have the adhesive aluminum foil already and can try that immediately. More ...EdHolland — 10:18 AM
Graphics for majestic 1050 dial glass.
Murf; I found this thread on the ARF, the first photo has a pretty good view of the dial glass. Regards ArranArran — 01:12 AM
Zenith H725
hello Ed, how about that speacial tape used for ducting it's like foil or how about thin piece of aluminum roof flash...radiorich — 12:19 AM

[-]
Who's Online
There are currently 2676 online users. [Complete List]
» 2 Member(s) | 2674 Guest(s)
AvatarAvatar

>