Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco rack (training aid)
#1

Hi,

During my military training (mid sixties) to become a radar technician in one of the practical labs a training aid was used. This equipment was referred to, as far as i remember, as the ‘Philco rack’. It comprised of a couple of about 3 by 1,5 feet metal racks in which all kind of units could be fitted. These units were all kind of basic electronic circuits (amplifier, oscillators, even thyristor circuits and wave guide parts). The resistors and capacitors could easily be replaced to perform all kind of measurements or experiments.

Now I tried to find some information on this equipment on the internet but was not successful. However I found this forum. And given the name of the rack I ask the question here. Can anybody give me or refer me to information on the internet of this training aid.
BTW I found a picture of some military in training with in the background the equipment I am talking about. This picture is attached.

Butch


Attached Files Image(s)
   
#2

Wow. Did the base barber shop close down for 6 months?

It's not how bad you mess up, it's how well you can recover.
#3

They allow those hairdos in the US Army?




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Shadow Meter Bulb
Phorum members, I am trying to find the bulb # for PHILCO Shadow Meter part number 45-2180 that is from a 37-640 chassis...georgetownjohn — 06:53 PM
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM

[-]
Who's Online
There are currently 5386 online users. [Complete List]
» 2 Member(s) | 5384 Guest(s)
AvatarAvatar

>