Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

I finally got one!
#1

A big surprise today after I tried to get this radio a year ago. The same guy who wanted the rediculous price for the Philco 70 had my friend working on a nice little 37-84 that I ha tried to buy from him over a year ago. While I was visiting my friend, the guy called and upon finding out I was there, sold the radio to me in working condition for a good bit less than he wanted for it when I tried to get it the first time. Other than needing the usual dial scale replacement, the rest of the radio is in good shape and preforms fairly well. The volume control has a touch spot near the bottom, but works fine for my needs. Icon_smile

   

No matter where you go, there you are.
#2

Congratulations Icon_clap - and it looks like it has a very nice photofinish, too, which is always a plus! Icon_thumbup

--
Ron Ramirez
Ferdinand IN
#3

Thanks, Ron. The photofinish is what first caught my eye on this unit when I saw it sitting on a high shelf in the former owner's back room roughly a year ago. I carefully got it down and after a bit of dusting I was able to see it still had a nearly perfect photofinish with just a bit of normal wear around the volume knob.

No matter where you go, there you are.
#4

Hello, Jay: that set is in nice condition! Well done!!
#5

Thanks again, TA. I was lucky to have gotten it and it's one of the few things my family given me grief over this week thus far. Seems I'm stuck in one of those "I can't do anything the like" ruts right now.

No matter where you go, there you are.
#6

Shoot... I've been divorced from my first wife for 11 years and it's STILL all my fault....
#7

Nice one. I have one of those also. Good little 4-tube performer! Just like my parents had when I was a little kid.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM
Model 28L
Hello, I'm restoring a Philco 28L and the output transformer is open. Part number of the transformer is 32-7020. Can...HORSTE — 10:32 AM

[-]
Who's Online
There are currently no members online.

>