Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

My Philco 38-116
#16

Arran, you are correct, I just like the right tubes in there. All glass. This radio was originally as you know set up with glass. Can't see them much with the shields on but the one I'm working on is missing the shield bases for the mag tuner 6J5s. Still stuck in glass and seems to do find. I like the glow. This chassis had one shield cut down due to the lower seat of the metal tube. I hated that. I had a proper shield and repaced the dang metal tube with glass. Threw away the cutdown shield, if the person who did the change would have just extended the grid wire it wouldn't have been so bad.
Jerry

A friend in need is a pest!  Bill Slee ca 1970.
#17

On the other end of the spectrum from the 38-116, my RCA 15K came out with and uses all metal tubes except the eye tube. Where even I prefer glass, I wasn't happy until I found my NOS metal 6L6 tube to replace the single glass 6L6 someone had put in the radio years before. Oddly, the new military surplus metal tube I put in was almost an exact match to the original RCA metal 6L6 in there when I tested it.

No matter where you go, there you are.




Users browsing this thread: 4 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM
Model 28L
Hello, I'm restoring a Philco 28L and the output transformer is open. Part number of the transformer is 32-7020. Can...HORSTE — 10:32 AM

[-]
Who's Online
There are currently no members online.

>