Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco T-9
#1

Hi, I was wondering if any of you have had any experience with the Philco T-9 Shortwave radio. I did a a Google search and not much came up. How do (did) they compare to the Zenith Transoceanic series shortwaves? Are there any mechanical woes that I should be aware of before purchasing one? Any what is a reasonable price on one of these in good condition? Thanks. Rich
#2

Nothing much out of the ordinary, in terms of trouble--they need their lytics replaced, just like any transistor radio of the same period.

They're much larger than the 1000 series, and they perform at the same level. Pretty good tone, if I remember correctly.

Bill
#3

Good radio. Check for excessive corrosion in the battery compartment, good antenna and handle and condition of leather covered case.

Some claim the Zenith performs better. There's probably not much difference if both are properly aligned.

The book stowed in the lid adds value. Figure on $50-$125, depending on condition. Recent prices may be higher.




Users browsing this thread:
[-]
Recent Posts
Restoration of the Canadian General Electric A-87
Great job on the cabinet. PS. In the US notation, "kenotron" refers to specific type of tubes; we call re...morzh — 08:24 AM
Part numbers to model cross
This document has at least some tables of models and parts used. Example: Choke 32-7572, used in 604 radio. S...morzh — 08:19 AM
Restoration of the Canadian General Electric A-87
I also checked all the radio tubes on my Hickok 530 tube tester. The 5Z3 kenotron turned out to be faulty, all the other...RadioSvit — 08:02 AM
Restoration of the Canadian General Electric A-87
Well... While the varnish is drying up, I started repairing the chassis... Of course I started by replacing the pa...RadioSvit — 07:12 AM
Philco Model 38-7: what caps & resistors do fail typically?
Hello Martin, Welcome aboard our little community what great Model 38-7 Sincerely Richardradiorich — 12:30 AM
Philco Model 38-7: what caps & resistors do fail typically?
Welcome to the Phorum Martin. I count about 9 paper caps, the 3 electrolytic caps and 2-Y2 safety caps to replace th...RodB — 09:44 PM
Part numbers to model cross
Jim, We have this index put together by Dale Cook but I don't think that is quite what you are looking for. The Parts...klondike98 — 09:37 PM
Philco Model 38-7: what caps & resistors do fail typically?
Yep the dim bulb test is OK but I'd definitely replace all those electrolytics before I did it. Since those #47 conden...klondike98 — 09:18 PM
Philco 42-345 Restoration/Repair
The resistor is a 2.2 Meg, it was the last one I hadn't replaced. The broadcast is coming in after replacing it.osanders0311 — 09:09 PM
Philco 42-345 Restoration/Repair
What does the resistor measure? I think it should be 3.3 Meg. If the oscillator coil has continuity and the resistanc...RodB — 09:03 PM

[-]
Who's Online
There are currently 1374 online users. [Complete List]
» 1 Member(s) | 1373 Guest(s)
Avatar

>