Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12, 2025) x

Thread Closed

A rediscovered Silvertone
#1

A call from my mom last week saying the bathroom sink wouldn't drain, led to a Saturday in the basement of their home replacing dwv lines for me!!! What fun!! Anyway, a lot of the sets from my early days of collecting reside in that basement. This one was off in a corner all but forgotten until I rediscovered it yesterdayIcon_clap So after cleaning up this morning, I dragged it out of there and brought it home! It's just like getting a new find except I didn't have to pay anything for it!!!!!
It's a Silvertone 4586, a ten tube set which, as I remember, didn't cost me anything back in the late '80s either. My mom found this one sitting by the curb for garbage pick up, so she loaded it up and brought it home for me! This was quite a big deal, as my mom wasn't very fond of my hobby in those daysIcon_lol
So, here it is at it's new home.
[Image: http://i1160.photobucket.com/albums/q500...5618f4.jpg]
[Image: http://i1160.photobucket.com/albums/q500...7b544e.jpg]
[Image: http://i1160.photobucket.com/albums/q500...c29262.jpg]
[Image: http://i1160.photobucket.com/albums/q500...4c486c.jpg]
#2

Looks like a good rediscovery.I really like that dial face. Are you going to restore it? MIke
#3

Appears to be a 1936 model.... found a video of one on YouTube:
https://www.youtube.com/watch?v=lUdQNSozAD8


I love the "magic" green tuning eyes those Silvertones used. My 1938 has one too... a 6U5 tube I believe (going by memory).

This is my set: https://www.youtube.com/watch?v=se21DYYGqTg

Greg V.
West Bend, WI
Member WARCI.org
#4

That dial's a real eye catcher. Nice.
#5

Boy that MOM is a KEEPER!!!
Nice set!
Terry
#6

NostalgiaRadioTime,

That radio looks so much like this one, but it's a bit different. The dial is different, with the broadcast band in the inner ring, instead of the outer ring like this one. Interesting difference...
#7

You're right Brenda! I hadn't looked that closely at the dial. Good eye!

Greg V.
West Bend, WI
Member WARCI.org
#8

BrendaAnnD,
I did a little research on this model Silvertone. Turns out that Silvertone used two different chassis types manufactured by two different companies. one by Colonial and the other by Stewart-Warner, which accounts for the slight differences in the dials due to tracking. Also the Stewart-Warner chassis has the tuning knob off to the right, whereas the Colonial chassis tuning knob is directly below the dial. My silvertone has the Colonial make chassis.
Mike,
I do intend on fully restoring this set. it will be quite a challenge though, as the cabinet has quite a few issues, i.e. loose joints, delamination on the sides and missing veneer. It is a very attractive radio and well worth the effort to bring her back.
Kevin
#9

Hope you can find time to post some pics as you go through the set. Good luck. Mike




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
54C Complete Teardown/Rebuild
Hello Roy, here is this one sincerely Richardradiorich — 12:45 AM
54C Complete Teardown/Rebuild
Richard, Had grabbed it already but thank you just the same.  I find myself wanting to find some way to block out the...glyphmon — 12:03 AM
54C Complete Teardown/Rebuild
Hello roy, here is a link to the schematic . Sincerely Richardradiorich — 11:54 PM
54C Complete Teardown/Rebuild
Richard, The Silvertone 2014 also is a transformerless set, so I am incorporating a 1:1 600 ohm audio isolation transfo...glyphmon — 11:37 PM
Preliminary work on wife's Silvertone 2014
Did an alignment today which was interesting.  IF alignment went great, almost all was already spot-on.  Adjusting on th...glyphmon — 11:35 PM
54C Complete Teardown/Rebuild
The main problem with adding a Bluetooth input is that this set lacks a traditional power transformer to isolate it from...radiorich — 11:19 PM
54C Cabinet Refinish
I started stripping this cabinet before it got super chilly out because I knew I wasn't going to be able to work on ...glyphmon — 11:18 PM
54C Complete Teardown/Rebuild
While I'm waiting to wrap up the final steps on my wife's Silvertone 2014, I started disassembly on the next project.  O...glyphmon — 11:07 PM
Preliminary work on wife's Silvertone 2014
Hello roy, that great news glad it worked out for you !! Sincerely Richardradiorich — 10:50 PM
Preliminary work on wife's Silvertone 2014
Safety caps arrived today.  Soldered one in and had a successful first power-up.  No magic smoke escaped and it tunes in...glyphmon — 09:53 PM

[-]
Who's Online
There are currently 1746 online users. [Complete List]
» 1 Member(s) | 1745 Guest(s)
Avatar

>