Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

48-482 Buttons
#1

Just brought home a 48-482 and from what I can see in examples from on-line photos there are supposed to be some type of clear plastic cover over top of the brown buttons.  Mine seem to be missing.
A) would someone who has a 48-482 be kind enough to post a close up picture of the clear cover and buttons for me. Do they just slip on over the brown portion?
B) Any idea of a source for them?
[Image: https://www.dropbox.com/s/6pcqo3xzpwg8zz....jpg?raw=1]
[Image: https://www.dropbox.com/s/ha9scio4p8sn5f....jpg?raw=1]
(All these questions and I haven't even blown the dust off it yet Icon_smile )  Thanks for the help!!
#2

I just finally finished my 48-482 and one of the first things I did was locate the covers.
If you email David at Antique Radio Collector: parts2many@aol.com and send him this photo, he should be able to fix you up.

   

Eric
The Villages, FL
Member: Philco Phorum, ARF, ARCI & Radiomuseum.org

#3

Thank you Eric!! Icon_biggrin I will get in touch with David. I just pulled the chassis out to try and do a quick cleaning to be sure there was nothing still alive inside. Fortunately no mice but pretty grungy and everything rubber is dried and shriveled. Unfortunately it was in the home of a smoker and is going to take a lot of cleaning to get the smell off. I'm sure I'll have more questions when I actually start into it.
#4

Now all you need is a super large cap inventory to get started. I'm putting in an order today so I can start on my 2nd 48-482. This one should be a piece of cake after all of the problems with my first one.

Eric
The Villages, FL
Member: Philco Phorum, ARF, ARCI & Radiomuseum.org

#5

And be prepared to change a lot of resistors as well. I picked up a 48-482 a couple of weeks ago and have started working on it. Some resistors have opened completely and others radically changed in value. Despite this, the radio actually worked to some extent as I received it.

Be sure to check the plate load resistor of the 7W7 RF amp tube, R502 (33K). It was open on two different sets I checked. With the open resistor the FM will work but the sensitivity will be low.
#6

Thanks Mondial! Yep, lots of caps and resistors to replace on this one.




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Correct model 84 Ac plug an cord type
Hello Arran Yes, I also like the lampshade style plug ! Sincerely Richardradiorich — 08:46 AM
Restoring Philco 38-14
Hello morzh, Nice explanation on the x and y capacitors and glad you are narrowing down the issue with this set ! Si...radiorich — 08:43 AM
Correct model 84 Ac plug an cord type
From what I read Philco went to using brown rubber power cords in 1936, so cloth was used in the 1935 and earlier models...Arran — 11:25 PM
Correct model 84 Ac plug an cord type
Hi Bruce, I have not worked on an 84, but in general, power cords for almost any radio prior to 1938 was cloth covered...MrFixr55 — 08:34 PM
Restoring Philco 38-14
OK, well, so after staring at the sch again, I realized the problem had to be the #12/12A padder. I put a scope on the o...morzh — 08:15 PM
Correct model 84 Ac plug an cord type
Hello Bruce, I mostly use brown far as my cloth powercords go ! Here is the plug that I have used bakelite Acorn style...radiorich — 08:05 PM
Correct model 84 Ac plug an cord type
Looking for as correct as can find the right Ac plug an the correct colored cloth line. Ive seen many old photos but mos...Bruce — 04:13 PM
Restoring Philco 38-14
Rod Two Y-caps make sense if you use them from L/N to the chassis; this is only makes sense in the transformer radios...morzh — 10:11 AM
Restoring Philco 38-14
Mike, I'm curious about a specific use of he Y cap. Lately I've seen a single cap across the power transformer primary. ...RodB — 09:01 AM
Restoring Philco 38-14
hello morzh , That sounds like a plan ! Sincerely Richardradiorich — 07:45 AM

[-]
Who's Online
There are currently 3986 online users. [Complete List]
» 1 Member(s) | 3985 Guest(s)
Avatar

>