Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Graybar 770 (Radiola 82)
#1

I had this radio offered to me a couple months ago, but passed on it because of price and the fact it wasn't one of the Radiola models I was aiming for. Well, I had it offered to me again today at a bit of a discount and since I was fuming a bit about driving all day for nothing, I bit and bought the set. To my amazement, this filthy radio actually came to life after I blew most of the crap off of it and brought it up slowly. I have only been running it at roughly 90-95% power, but I hear no hum and the new cord leads me to believe this unit at least had the power chassis serviced sometime in the past. Also this thing is a hot performer that sounds good and even can pull in my local station without the antenna! Only issue I have is the tuner. I either have a plate scraping or need to blow more crud out of it as it crackles like crazy when I am tuning until I get above 1000. I think I am in love with this radio though. Icon_smile

   

No matter where you go, there you are.
#2

Beautiful piece. From end of 1920-s to 1930 I guess?
#3

Not bad, I think it's an early superhet design hence the decent performance. There were a few G.E and Westinghouse sets that used that same setup as that Greybar.
At least whoever you bought the set from got the message about the price somewhat and reduced it to sell. One radio I looked at about a month ago, was a Canadian Westinghouse model 80 also from 1930 but it was a TRF. The seller wanted $150 for it and it was listed for two months at that price in spite of the fact that it needed refinishing, has mostly ST style tubes, and is in unknown condition electrically.
Now the set has ended up in a local junk "consignment" shop for $350, well if it didn't sell after two months on craigslist what makes these chuckleheads in the shop think they can get $350 for it if the current owner couldn't get $150? That shop has exactly the same clientele that Craigslist has, in fact they post a lot of their crap on C.L to try and sell it, they don't think that someone will recognize it? The first thing anyone is going to ask is that magic question "Does it work?" the answer is of course going to be "No", unless the dummies try plugging it in, they they will say "Oh" and walk away. Nobody is going to give them anywhere near $350 that for that thing for the same reasons that nobody is going to give them $65 for a Guild "Country Belle".
Regards
Arran

P.S It also has a price of $170 written on the chassis with a felt tip pen, that was likely the price the current owner paid for it if not less.
#4

Jayce, that is a really nice looking radio. Love the styling and with some clean up on the cabinet it will be stunning. Nice find.
Jerry

A friend in need is a pest!  Bill Slee ca 1970.
#5

Thanks! I am hoping to straighten out the tuner problem issue later on this week. Other than that, the radio seems good and is a nice performer. One of those cases of a radio that performs as nice as it looks. Icon_smile

No matter where you go, there you are.
#6

You have the same taste as I do in liking that old leg styling on radios. I really like my Philco 111. I just brought home a relatively unknown radio because I liked the cabinet style. I have not started on it but looking forward to try to figure out what it is. Thus far, no real ID and no schematic. Should be fun. Attached is a link to the thus not identified radio. Probably not a high production but I like the cabinet style. Yours is lovely.
Jerry

http://www.ebay.com/itm/Antique-30s-Cath...7675.l2557

A link to the discussion on the radio;

http://antiqueradios.com/forums/viewtopi...1&t=223590

A friend in need is a pest!  Bill Slee ca 1970.
#7

That looks like an interesting radio as well. Hopefully you get some info on it! It's a bit like the Sterling radio I owned for a short bit.

No matter where you go, there you are.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
American Bosch Model 802 auto radio
Hello again;   I found a model 838 car radio on Nostalgia Air under United American Bosch, http://www.nostalgiaair.org/...Arran — 09:32 PM
New Philco Repair Bench
Morzh is correct. The repair bench on our website is an archived image of chuck’s original site. He no longer provides s...klondike98 — 05:32 PM
Made mistake & did not label connection
Excellent information. It is all starting to come together now and your explanation really helped since I noticed that ...georgetownjohn — 04:39 PM
Made mistake & did not label connection
Hi John, I don't have this radio, but I can supply some info: Based on your pic, pins 7,8 and 1 are used together, go...MrFixr55 — 02:02 PM
New Philco Repair Bench
As far as I know, the Repairbench does not work, and has not been working in a while. Chuck (we had that campaign looki...morzh — 01:33 PM
Radio city products 664 schematic request
Need a schematic or manual for the 664. The 663 may be similar.daveone23 — 12:38 PM
New Philco Repair Bench
Thanks Gary.dconant — 12:16 PM
New Philco Repair Bench
I tried accessing the site through our library and got the same response. It's reported to our tech gurus. GaryGarySP — 11:50 AM
New Philco Repair Bench
I am sure this is the archive, and not the Chuck's site.morzh — 09:50 PM
Made mistake & did not label connection
It's not like we are good friends with that wire and can tell it from other ptetty identical looking wires. Why'n't you...morzh — 09:49 PM

[-]
Who's Online
There are currently 4028 online users. [Complete List]
» 1 Member(s) | 4027 Guest(s)
Avatar

>