Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 40-158
#1

I just received a Philco model 40-158. I'm new to the hobby, but have wanted to restore an old floor radio for some time!! The cabinet is in good condition, but the faceplate is missing. Can anyone tell me where to go to find a faceplate for this particular model? I've looked at a bunch of sites on the net, but fail to find anything. Also, does anyone have a photo of this model that shows the close up views? I have purchased the book by Ron Ramirez...excellent read!! Icon_biggrin
#2

Hi

Unfortunately the only way you are going to find the bezel for your radio is to obtain one from a junk 40-158, 40-160 or 40-165. You might try the Radio Junkyard.
http://www.vintage-electronics.com/
(scroll down for the Radio Junkyard link)

Glad you like the book. It isn't the one I wanted to publish..it is essentially the original 1993 edition with new covers.

--
Ron Ramirez
Ferdinand IN
#3

Thanks for the help. Are the 40-160 and 40-165 basically the same style radio as the 40-158?
#4

Yes.

--
Ron Ramirez
Ferdinand IN




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Shadow Meter Bulb
Phorum members, I am trying to find the bulb # for PHILCO Shadow Meter part number 45-2180 that is from a 37-640 chassis...georgetownjohn — 06:53 PM
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM

[-]
Who's Online
There are currently 4855 online users. [Complete List]
» 1 Member(s) | 4854 Guest(s)
Avatar

>