Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 37-84 feet and/or back?
#1

Hi all! Can anyone please tell me what kind of "feet" the 37-84 had and if it happened to have a back? Thanks So much!
#2

Very few radios in that era had backs and the 37-84 was not one of them, if it was a 37-116 then it would have had a back. As for feet I think that it may have had short rubber feet that were tacked onto the bottom of the cabinet, some sets had thick felt pads rather then rubber ones.
Regards
Arran
#3

Don't think it had either.
Terry
#4

There was another kind that weren't really feet as such, but they were these round metal runners, about 3/8'' wide, with a felt pad crimped into the center, some were nailed on and some had a screw holding them on. If this set had those originally then they would probably still be there, they aren't the kind of thing that would just fall off.
Regards
Arran
#5

It's pretty much always OK to get a set of tack like feet with felt or rubber bottoms for a wooden cabinet radio to keep it from maring anything it is placed upon. Look carefully for tack holes where the originals might have been, if there were any. Stick on felts usually don't work out well on wooden bottom radios.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM
Model 28L
Hello, I'm restoring a Philco 28L and the output transformer is open. Part number of the transformer is 32-7020. Can...HORSTE — 10:32 AM
Philco 42-1008 conversion kit
I read about a kit to convert the variable speed changer in the Philco 42-1008 into a single speed unit.  That would rem...alangard — 09:30 PM
HiFi (Chifi) tube amp build - but my own design.
Tim Well...a chassis is metal. Magnetic or not, it does not matter. A transformer has some hum to it. It is natural. Th...morzh — 08:40 PM
Hickok AC51 tube tester
I thought the 83 tube was bad because it looked white but it tests strong. Blue gassy though. I checked the fuse, it was...martinj — 08:37 PM
Shadow Meter Bulb
Ross I am not sure what current limiting effect the incandescent provides. They are two different parts of the sch...morzh — 08:31 PM
12' Philco
Bob Thanks for that photo. I have been looking for it, and I cannot find anythinmg on the web. I forgot it was here...morzh — 08:29 PM
Shadow Meter Bulb
I think after all has been said, I will use the same bulb that is specified for the dial pilot light which is a #55. I ...georgetownjohn — 07:31 PM

[-]
Who's Online
There are currently 6001 online users. [Complete List]
» 2 Member(s) | 5999 Guest(s)
AvatarAvatar

>