Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 45
#1

Hi All;
I went and did it, I got another chassis.. Chassis seem to be about all I can afford with shipping and all.. I got a Philco 45, it was listed as a Philco 29 45, but the label of the Back of it shows a 45.. Don't know anything about it, it should be here by the end of the week..
I though that having a two bander might simpliify my getting something working and my troubleshooting and aligtnment skills.. I can leave it on the broadcast band and see about making it work.. I will update everyone once it gets here..
The 28, 29, 39, and 45 have all the same/similiar front end all being a two bander, the only exception is the converter tube used.. 1C6 vs 6A7..
THANK YOU marty
#2

The 1C6 is a tube for a battery-operated radio. Battery sets are simple and easy to fix. Building a power supply is easy too since there are innumerable ways of doing it.
#3

Hi All;
Bill. If you have kept up with all of my postings on my Battery set Philco 34, that uses the 1C6, you would notice that I am and have had innermable trouble with it.. Which Is part of the Reason that I am getting the Philco 45, something simplier to try and get going..
I have a Power Supply that is great for my 34.. (Home built)
THANK YOU marty
#4

Hi All;
I Got the Philco 45 and Speaker today.. I found out After posting about a transformer that He had the Speaker for it, so I got it..
Its quite Dusty and Dirty.. So I will need to do some cleaning up..
I will Replace the Electrolytics and see with my Variac what happens..
Then I will replace a Cap at a Time, making sure that I have it wired correct and it isn't any worse.. I think that is part of some of my problems with my Philco 34.. Just letting Everyone know.. For Now until I can get the funds I will use the pages from Nostalgiaair, then get a set from Chuck when I am able to afford it..
THANK YOU Marty
#5

Hi All;
Well, Considering what I have, I feel I am very Blessed.. I replaced the three electrolytic Caps and put it on the Variac..
I got a station very weak and with lots of squeeling, but it was there..
But, after, a minute or so I suddenly hear a pop! and I have no sound..
So, for a first try, I feel that what I got is Great !!!
THANK YOU Marty




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
The list of my radio & TV collection!
A little light positivity in our feed... To nostalgic retro music... With English subtitles My new video on the contin...RadioSvit — 02:14 PM
My Philco 37-116 Restore
Ron and Mike I mentioned a 2 meg resistor not on the schematic. I stumbled on a changes note in Riders that mentioned th...dconant — 12:02 PM
Need Help to ID this radio 11 tube Philco
Here you go: Your the code 125Radioroslyn — 11:12 AM
My Philco 37-116 Restore
Hi Ron, Thanks for the input. I think I'm going to call it good enough. It does seem weird I can usually dial in othe...dconant — 08:01 AM
Need Help to ID this radio 11 tube Philco
Welcome, the radio looks intimating 11 tubes, wish you well.Jimradio — 07:49 AM
462ron
Hi Dan, it’s been 10 years since I restored the electronics on my 37-116 so I’m going on some foggy memories. I remember...462ron — 07:37 AM
Need Help to ID this radio 11 tube Philco
Yes the 16B as morzh pointed out. Specifically its the January 1935 model version of the 16B. There are a couple earli...klondike98 — 11:51 PM
48-482 rear panel help
Welcome to the Phorum, keithchip! How far you take a radio on cabinet restoration is a matter of personal preference. ...GarySP — 11:28 PM
48-482 rear panel help
I've recently finished the internal restoration of a locally purchased Philco 48-482. The cabinet is in ok shape except ...keithchip — 10:28 PM
Need Help to ID this radio 11 tube Philco
Welcome to the Phorum, Ken! Lots of help here for all of your restoration questions. Take care and BE HEALTHY! - Gar...GarySP — 07:59 PM

[-]
Who's Online
There are currently 480 online users. [Complete List]
» 1 Member(s) | 479 Guest(s)
Avatar

>